Yamaha RX-V365 - Инструкция по эксплуатации - Страница 20

16

 En

This unit has the Yamaha Parametric Acoustic Optimizer (YPAO). With the YPAO, this unit automatically adjusts output 
characteristics of your speakers based on speaker positions, speaker performances, and acoustic characteristics of the 
room. We recommend that you first adjust the output characteristics with the YPAO when you use this unit.

y

•

Initial settings are indicated by (*) in the following each parameter.

1

Make sure of the following check points.

Before starting the automatic setup, check the 
following check points.

•

All speakers and subwoofer are connected 
appropriately.

•

Headphones are disconnected from this unit.

•

This unit is turned on.

•

The connected subwoofer is tuned on and the 
volume level is set to about half way (or slightly 
less).

•

FRONT A speakers are selected as the front 
speaker system (see page 19).

•

The room is sufficiently quiet.

•

The crossover frequency control of the connected 
subwoofer is set to the maximum.

2

Connect the supplied optimizer microphone 
to the OPTIMIZER MIC jack on the front 
panel.

“SETUP•••••AUTO” appears on the front panel 
display.

3

Place the optimizer microphone at your 
normal listening position on a flat level 
surface with the omni-directional 
microphone heading upward.

y

•

We recommend that you use a tripod (etc.) to affix the optimizer 
microphone at the same height as your ears would be when you are 
seated in your listening position. You can use the attached screw of 
a tripod (etc.) to fix the optimizer microphone to the tripod (etc.).

4

Press 

o

l

 / 

h

 to select “AUTO.”

Note

•

“RELOAD” or “UNDO” is available only when you have 
previously run “AUTO SETUP” and confirmed the results.

5

Press 

o

ENTER

 to start the setup 

procedure.

This unit starts the automatic setup procedure. Loud 
test tones are output from each speaker during the 
audio setup procedure. After all settings 
(“INITIALIZING,” “WIRING/LEVEL,” 
“DISTANCE,” “SIZE”) are sequentially completed, 
“FINISH” appears on the front panel display.

y

•

To cancel the automatic setup, press 

o

k

.

Optimizing the speaker setting for your listening room (YPAO)

Notes

•

Be advised that it is normal for loud test tones to be 
output during the “AUTO SETUP” procedure. Do not 
allow small children to enter the room during the 
procedure.

•

To achieve the best results, make sure that the room 
is as quiet as possible while the “AUTO SETUP” 
procedure is in progress. If there is too much ambient 
noise, the results may not be satisfactory.

Using AUTO SETUP

VOLUME

MIN

MAX

MIN

MAX

CROSSOVER 

HI

G

H CUT

Controls of a subwoofer (example)

Choice

Function

AUTO

*

Automatically runs the entire “AUTO 

SETUP” procedure.

RELOAD

Reloads the last “AUTO SETUP” settings and 

overrides the previous settings.

UNDO

Undoes the last “AUTO SETUP” settings and 

restores the previous settings.

DEFAULT

Resets the “AUTO SETUP” parameters to the 

initial factory settings.

Optimizer microphone