Dreame W10 - Инструкция по эксплуатации - Страница 9

14

15

EN

EN

6. Clean the mop pad

How to Use

Note: 

· If the robot is not on the base, please put it back before starting it.

· The robot will clean the mop pad before cleaning, please wait patiently until the  

   mop pad is cleaned. 

· Do not manually move the base, fresh tank, waste tank, or washboard while mopping.

Note: 

· To clean the mop pad at any time, press and hold the   button on the base for 3  

  seconds to start cleaning.

· While cleaning the mop pad, if the water in the fresh tank is insufficient or the waste tank 

  is full, the robot will send a voice prompt, or the app will send a notification.

· After the robot completes mopping, clean the waste tank in time to avoid mold or odor.  

  It is recommended to change the mop pad every 1 to 3 months.

After the robot completes cleaning and returns to charge, the base starts 

cleaning and drying the mop pad.

3.  Place the robot onto the base

5. Return to self-clean
While mopping, the robot will return to the base to have the mop pad cleaned 

as cleaning conditions set in the app. The robot resumes cleaning after the 

mop pad is cleaned.

Press briefly the   button. The robot starts from the base and mops the house 

based on the optimal cleaning plan scheduled by the map.

4. Start mopping

How to Use

Functions in APP

1. Map management

The homepage of the app displays the current map. On this page, No-Go 

Zone allows you to set zones to be avoided, and Map Management allows 

you to modify the current map .

For optimal performance, follow the instructions below to clean and maintain 

the robot and base. 

2. Cleaning mode settings

Cleaning Mode on the homepage allows you to change the cleaning mode, 

the suction power, as well as the humidity of the mop pad.

3. Self-cleaning settings

Self-Cleaning Settings on the homepage allows you to change the frequency 

for self-cleaning and manually start a mop pad cleaning task or manually 

start or end a mop pad drying task.

4. Product settings

The Settings page allows you to enable or disable device functions, configure 

scheduled cleanup, or view cleaning history and device information.

Note:

· A map must be created before you use the room- or zone-based cleaning, and  

  manage maps.

· For more information about functions, check the corresponding interfaces or 

  guides in the app.

· The version of the app might have been updated, please follow the instructions 

  based on the current app version.

Routine Maintenance

Parts

Part

Maintenance Frequency

Replacement Frequency

Dust Bin

Clean it as needed

/

Dust Bin Filter

Once every 2 weeks

Every 3 to 6 months

Fresh Tank

Once every 2 weeks

/

Fresh Tank Filter Media

Once every 2 weeks

/

Waste Tank

After each use

/

Washboard

Once every 2 weeks

/

Main Brush

Once every 2 weeks

Every 6 to 12 months

Side Brush

Once every 2 weeks

Every 3 to 6 months

Mop Pad

Once every month

Every 1 to 3 months

Universal Wheel

Once every month

/

Auxiliary Wheel

Once every month

/

LDS Laser Sensor

Once every month

/

Return-to-Base Sensor

Once every month

/

Cliff Sensors

Once every month

/

Signaling Area on Base

Once every month

/

Overflow Sensors on Base

Once every month

/

Charging Contacts on Robot

Once every month

/

Charging Contacts on Base

Once every month

/

Bottom of the Robot

Once every month

/

Body of the Base

Once every month

/

Note: 

 The replacement frequency will depend on your usage of the robot. If an 

exception occurs due to special circumstances, the parts should be replaced.