Dreame W10 - Инструкция по эксплуатации - Страница 7

10

11

EN

EN

The appliance works with the Mi Home/Xiaomi Home app, which can be used to control the appliance and make it interact with other smart devices.

1. Download the Mi Home/Xiaomi Home App

Scan the QR code on the robot to download and install the Mi Home/Xiaomi 

Home app.

2. Add Device

3. Reset Wi-Fi

Note:

 If the robot cannot connect to your phone, Reset the Wi-Fi network and try 

again.

Wi-Fi Indicator

· Blinking slowly: To be connected
· Blinking quickly: Connecting
· On: Connected

Connecting with Mi Home/Xiaomi Home App

xxxxxx' s  home

No home environment info

Devices            Rooms

Add a device

Scan

Note:

·

Only 2.4 GHz Wi-Fi is supported.

·

The app software is upgrading, and the actual operations may be different from 

the statements in this manual. Please follow the instructions based on the current 

app version.

 Under the Cover

Open the Mi Home/Xiaomi Home, tap "      " in the upper right, and then 

scan the QR code above again to add "Dreame Bot W10". Please follow the 

prompts to finish the Wi-Fi connection.

Simultaneously press and hold the

and

 buttons until you hear a voice 

prompt saying, "Waiting for the network configuration." Once the Wi-Fi 

indicator is blinking slowly, the Wi-Fi has been reset.

1. Remove the protective strips

2. Install the side brush

Preparations Before Use

3. Place the base against the wall and charge the robot

Note:

·

Remove any objects that are closer than 1.5 m from the front and 5 cm from either 

side of the base.

·

Make sure that no objects might block the signaling area.

·

To prevent water stains from wetting wood floors or carpets, the self-wash base is 

recommended to be placed on tile floors or marble floors.

> 1.5 m

> 5 cm

> 5 cm

Within the Best 

Wi-Fi Range

·

Install the base in as open a location as possible with a good Wi-Fi signal.

·

Insert the power cord into the base and plug it into the socket.

·

Place the robot onto the base, and the robot will trun on automatically and 

start charging.

·

It is recommended to fully charge the robot before the first use. After the 

robot is fully charged, the status indicator illuminates white for 10 minutes 

and then lights down.

Click

 Install the side brush 

until it clicks into place.