AQT 37-13 Bosch 0.600.8A7.200 - Инструкция по эксплуатации - Страница 10

 English | 

9

Bosch Power Tools

F 016 L70 995 | (10.6.13)

Nur für EU-Länder:

Gemäß der Europäischen Richtlinie 

2012/19/EU über Elektro- und Elektronik-

Altgeräte und ihrer Umsetzung in nationales 

Recht müssen nicht mehr gebrauchsfähige 

Elektro- und Elektronikgeräte getrennt ge-

sammelt und einer umweltgerechten Wie-

derverwertung zugeführt werden.

Änderungen vorbehalten.

English

Safety Notes

Explanation of symbols

General hazard safety alert.

Never direct the water jet at people, ani-

mals, the unit or electric components.

Warning: High pressure jets can be dan-

gerous if subject to misuse.

According to the applicable regulations, the 

appliance must never be used on the drinking 

water network without a system separator. 

Use a separator as per IEC 61770 Type BA. 
Water flowing though a system separator is 

considered not drinkable. 

Safety Notes for pressure washer

Read all safety warnings and all instructions. 

Failure to follow the warnings and instructions 

may result in electric shock, fire and/or serious in-

jury.

The warning and information signs attached to the unit 

provide important information for safe operation.
Apart from the information in the operating instructions 

comply with the general safety regulations and regula-

tions for the prevention of accidents.

Power supply



The voltage indicated on the rating plate must correspond 

to the voltage of the power source.



We recommend that this equipment is only connected into 

a socket which is protected by a circuit-breaker that would 

be actuated by a 30 mA residual current.



Remove the plug from socket whenever the machine is left 

unattended for any period.



The electric supply installation should comply with 

IEC 60364-1.



If the supply cord is damaged, it must be replaced by the 

manufacturer, its service agent or similarly qualified per-

sons in order to avoid a hazard.



If the plug is damaged, pay attention to the following:



Plugs and sockets situated near the work site or outdoors 

should be to class IP 55 of BS 5490 to provide adequate 

protection against ingress of water, etc. and cable entries 

require effective sealing. Rubber shrouds should be pro-

vided over cable glands. Drip-proof (class IP X2 of 

BS 5490) plugs and sockets to BS 4343 are suitable for 

use indoors where the plug is away from the water spray 

area where the appliance is in use.



Never touch the mains plug with wet hands.



Do not pull plug while operating the device.



Do not run over, crush or pull the power supply cable or ex-

tension lead, otherwise it may be damaged. Protect the ca-

ble from heat, oil and sharp edges.



Do not use the appliance, if the power supply cable or im-

portant parts, e. g. high-pressure hose, trigger gun or safe-

ty devices are damaged.



Warning: Inadequate extension cords can be dangerous.



If an extension cord is used, the plug and socket must be of 

watertight construction. The extension cord must have a 

cross section in accordance with the operating instruc-

tions and be protected against splashed water. The con-

nection must not be in water.



When replacing plugs on the power supply cable or exten-

sion lead the spray water guard and mechanical stability 

must remain intact.

Water connection



Comply with the regulations of your water supply compa-

ny.



All connecting hoses must have properly sealed joints.



Make sure that the supply hose is at least 12.7 mm (1/2") 

in diameter and is reinforced.



The appliance should never be used on the drinking water 

supply without a back flow valve. Water which has passed 

the back flow valve is regarded as undrinkable.



The high-pressure hose must not be damaged (danger of 

bursting). A damaged high-pressure hose must be re-

placed immediately. Only use hoses and connections rec-

ommended by the manufacturer.



High-pressure hoses, fittings and couplings are important 

for the safety of the appliance. Use only hoses, fittings and 

couplings recommended by the manufacturer.



Only clean or filtered water should be used for intake.

Application



Before use, check that the unit and operating equipment 

are in perfect condition and are safe to operate. Do not use 

the unit if it is not in perfect condition.



Do not direct the jet against yourself or others in order to 

clean clothes or footwear.



Never draw in solvent-containing liquids, undiluted acids, 

acetone or solvents! This includes petrol, paint thinners, 

heating oil. The sprayed vapour is highly flammable, explo-

sive and toxic.

OBJ_BUCH-1953-004.book  Page 9  Monday, June 10, 2013  10:39 AM