Fulgor Milano FCO 4512 TM X - Инструкция по эксплуатации - Страница 74

EN

34

4.  Slide out the internal glass as shown below. Remove the second 

and third panes of glass (middle panes) for cleaning sliding out the 
rubber strip.

5.  Replace the middle panes after cleaning in reverse order, checking 

that they are oriented so the words INTERNAL SIDE are properly 
legible.

NOTE:  a slight gap between the middle panes and the side supports 

is normal because it allows for the heat expansion of the 
glass.

6.  Place the pack of three glass panes between the two uprights and 

replace the top strip. 

Replacement of the oven light

WARNING

Make sure that: 
• 

The oven and lights are cool and power to the oven has 

been turned off before replacing the light bulb(s). Failure to do so 
could result in electrical shock or burns. 

• 

The lenses must be in place when using the oven. 

• 

The lenses serve to protect the light bulb from breaking. 

• 

The lenses are made of glass. Handle carefully to avoid 

breakage. Broken glass could cause an injury.

1

3

2

(230V - 25W  G9)

1

3

(230V - 15 or 25W)

2

2

(230V - 25W  G9)

1

1  Turn off power at the main power supply (fuse or breaker box). 
2  Remove the lens (1).
3  Remove the light bulb (2) from its socket (3).  
4  Replace the bulb (2) with a new one. Avoid touching the bulb with 

fingers, as oils from hands can damage the bulb when it becomes 
hot. 

5  Use one with the same Volt and Watt (see figure). 
6  Screw the lens (1) back on. 
7  Turn power back on at the main power supply (fuse or breaker 

box).