Fulgor Milano FCO 4512 TM X - Инструкция по эксплуатации - Страница 50

EN

10

Connection to the electrical power mains

WARNING

This apparatus must be earthed. 

The oven is only for domestic use. 
The feed voltage and the absorbed power are as indicated on the data 
plate attached to the left-hand side upright, which can be seen when 
the oven door is open. 
Connecting must be carried out by qualified personnel and in 
accordance with the regulations currently in force. 
The manufacturer can not be held responsible for any damages to 
persons or objects caused by failure to observe these instructions. 
If the supply cord is damaged, it must be replaced by the manufacturer, 
its service agent or similarly qualified persons in order to avoid a 
hazard. 
The oven must be connected to the mains through a multipole circuit 
breaker with a contact-to-contact gap of at least 3 mm, making sure 
that the earth wire is not disconnected. For connecting use a flexible 
cable remembering to make it long enough to allow the oven to be 
removed from its housing unit when maintenance work is required.
Such a device must be fitted to the power supply in compliance with 
the regulations
governing electrical installations.

The socket or switch must be easily reachable with the oven fully 
installed.

CABLE TYPES AND MINIMAL DIAMETERS

SASO

H05RR-F

3x1,5 mm²

H05RR-F

3x2,5 mm²

H05VV-F

3x1,5 mm²

H05VV-F

3x2,5 mm²

H05RN-F

3x1,5 mm²

H05RN-F

3x2,5 mm²

H05V2V2-F

3x1,5 mm²

H05V2V2-F

3x2,5 mm²