Fulgor Milano FCO 4512 TM X - Инструкция по эксплуатации - Страница 72

EN

32

18 - Oven Care and Cleaning

Abrasive detergents and steam cleaning equipment should not be used 
for cleaning.

WARNING

Do not use harsh abrasive cleaners or sharp metal scrapers to clean 
the oven door glass since they can scratch the surface, which may 
result in shattering of the glass.

Clean

Assisted cleaning (NOT AVAILABLE ON FCO 4512 TM 

MODELS)

High temperature cycle (250°C), combined with self-cleaning panels 
for gentle, non-invasive cleaning of the cooking chamber.
Correct operation is combined with the use of the lateral panels and 
catalytic fan cover: the oven is treated with  special enamel with a 
micro-porous structure, which breaks down the fat projected thanks to 
a catalytic oxidisation process which transforms residues into gaseous 
products. 
The turbo clean function is only activated when no cooking function has 
been selected, so: switch on the oven and touch the symbol as shown 
in the figure for five seconds.

WARNING

The cleaning process takes place at a temperature of 250°C and 
lasts one hour. Do not use it for cooking food!!

The oven light is activated and can be switched off and on again at 
any time.
All the self-cleaning panels will perform effectively for thirty cleaning 
processes, after this limit the panels must be replaced. 
The panels should be cleaned exclusively with tap water and 
replacements can be ordered from your specialised dealer.

Removing the door

WARNING

Make sure that:
• 

The oven is cool and power to the oven has been turned 

off before removing the door. Failure to do so could result in 
electrical shock or burns. 

• 

The oven door is heavy and fragile. Use both hands to 

remove the oven door. The door front is glass. Handle care-fully 
to avoid breakage. 

• 

Grasp only the sides of the oven door. Do not grasp the 

handle as it may swing in your hand and cause damage or injury. 

• 

Failure to grasp the oven door firmly and properly could 

result in personal injury or product damage. 

Removing the standard oven door

The oven door can be removed quickly and easily. To do so, proceed 
as follows:
• 

Open the door fully.

• 

Lift the two levers shown below.

• 

Close the door as far as the first stop (caused by the raised 

levers).

• 

Lift the door upwards and outwards to remove it fromits 

mountings.

To replace fit the door, fit the hinges in their mountings and lower the 
two levers