Karcher SC 5 EasyFix Iron Plug - Инструкция по эксплуатации - Страница 17

– 10



Open the maintenance lock. For this, place the 
open end of an extension pipe onto the mainte-
nance lock, lock it into the guide and unscrew it.

Illustration 



Completely empty the steam boiler to remove exist-
ing water. 



Use KÄRCHER descaler sticks for descaling. 
Please follow the dosing instructions on the pack-
aging when preparing the descaler.



Pour the descaling solution into the boiler and allow 
it to react for approximately 8 hours.



Completely empty the descaling solution after 8 
hours. A small amount of the solution will remain in 
the boiler. Therefore, you should rinse the boiler 
two to three times with cold water to remove any 
residues of the descaler.

Illustration 



Completely empty the steam boiler to remove exist-
ing water. 



Screw the maintenance lock in using the extension 
pipe.



Fill the water reservoir



The steam cleaner is ready to use.

Note

The floor cleaning cloth and the cloth cover have been 
pre-washed and can be used immediately for working 
with the steam cleaner.



You can wash dirty floorcloths and cloth covers in 
the washing machine at 60°C. Do not use a liquid 
softener as this would affect the ability of the cloths 
to pick up dirt. You may tumble dry the terry cloths. 
The microfiber cloths are not suitable for the tum-
ble.

Often, failures have simple causes and you can do the 
troubleshooting yourself using the following overview. If 
you are in doubt or if the failure is not listed here please 
contact the authorized customer service.



Descale the steam boiler.

No water in the water reservoir.



Fill the water reservoir up to the "MAX" marking.

No water in the steam boiler. Overheating protection of 
the pump was triggered.



Turn off the appliance. 



Fill the water reservoir up to the "MAX" marking.



Turn on the appliance.

Water reservoir has not been inserted properly or is cal-
cified.



Remove the water reservoir and rinse it.



Insert the water reservoir and press downwards un-
til it arrests.

Steam switch is secured with the lock / child-proof lock.



Move the child protection unit forward.



Set the thermostat to level •••.



Rinse or decalcify the boiler of the steam cleaner.

During longer breaks from ironing, the steam in the 
steam line can condense.



Direct the first burst of steam at a separate piece of 
cloth.



Descale the steam boiler.

Subject to technical modifications!

Care of the Accessories

Troubleshooting

Long heating-up time

Steam boiler is decalcified

No steam

Display - water shortage blinks red and signal is 
emitted.

Display - water shortage lights up red.

Steam lever cannot be pressed anymore

Steam iron "spits out" water!

After ironing breaks, water drops come out of the 
steam pressure iron

High water output

Steam boiler is decalcified

Technical specifications

Electrical connection

Voltage

220-240

V

1~50

Hz

Protection class

IPX4

Protective class

I

Performance data

Heating output

2200

W

Heating output steam iron

700

W

Operating pressure max.

0,42

MPa

Heating time

3

Minutes

Steam volume
– Continuous steaming

60

g/min

– Steam push max.

150

g/min

– Vapohydro

250

g/min

Filling quantity

Water reservoir

1,5

l

Boiler capacity

0,5

l

Dimensions

Weight (without accessories)

6,0

kg

Length

439

mm

Width

301

mm

Height

304

mm

17

EN