Bosch MFW 3710B - Инструкция по эксплуатации - Страница 17

 17

en

Before using for the first time

Before using for the first 

time

Before the new appliance can be used, 

it must be fully unpacked, cleaned and 

checked.

Caution!

Never operate a damaged appliance!

■

Remove the base unit and all 

accessories from the packaging.

■

Remove the packaging material that is 

present.

■

Dismantle any assembled parts into 

their individual parts. Do this in reverse 

order, as described under „Preparation“.

■ Check all parts for completeness. 

X

Fig. 

A

 / 

B

■

Inspect all parts for visible damage.

■

Thoroughly clean and dry all parts 

before using for the first time.  

X

 “Care and daily cleaning” see 

page 19

Control and display elements

Button 

ä

Press button 

ä

 to switch on the appliance. 

The drive will start up at once.

Button 

ö

Press button 

ö

 to switch off the appliance. 

The drive stops.

Operation indicator

The operation indicator lights up when the 

appliance is switched on. 

Release button

Press the release button to unlock an 

attachment fitted on the appliance. Only 

when the release button is pressed is it 

possible to turn the attachment clockwise 

and remove it from the base unit.

Cable storage compartment

The mains cable can be pulled out of the 

cable storage compartment or pushed back 

in again. Only ever pull the cable out as 

much as is required.

Storage compartment

Unused perforated discs belonging to the 

meat mincer can be kept in the storage 

compartment and it closed with the cover.

Overload protection

To prevent serious damage to your 

appliance if the base attachment is 

overloaded, the agitator paddle has a 

notch (predetermined breaking point). 

If overloading occurs, the agitator paddle 

will break at this point. A new agitator 

paddle is available from Customer 

Service (No. 630701). Spare parts with 

a predetermined breaking point are not 

covered by our warranty obligations.

Replace agitator paddle

X

Fig. 

C

1. 

Release the screw in the agitator paddle 

with a screwdriver (PH2) and remove 

the faulty paddle.

2. 

Fit a new agitator paddle and screw tight 

again.

Base unit

Preparation

W

Risk of injury!

Do not insert the mains plug until all 

preparations for working with the appliance 

are complete and the required attachments 

are assembled correctly and connected to 

the base unit.

■

Place the base unit on a stable and level 

work surface.

■

Pull the mains cable out of the cable 

storage compartment to the required 

length.

The base unit is now prepared.