Immergas 6 - Инструкция по эксплуатации - Страница 9

9

INS

T

ALLER

US

ER

MAINTEN

A

N

C

E TECHNI

CI

AN

TECHNI

CAL D

A

T

A

For the aforementioned reasons, we recommend not placing furnishings, furniture, etc. under the indoor unit.

Any modification to the appliance that is not explicitly indicated in this section of the booklet is forbidden.

In any configuration do no install the indoor unit and outdoor unit at altitudes above 2000 m.

Installation standards

This indoor unit can be installed outdoors in a partially protected area.
A partially protected area is one in which the indoor unit is not exposed to the direct action of the weather (rain, snow, hail, etc.).

This type of installation is possible when permitted by the laws in force in the appliance's country of destination.

Do not install on the vertical projection of hobs.

Do not install in places/rooms that constitute public areas of apartment buildings, internal 
stairways or other escape routes (e.g. floor landings, entrance halls, etc.).

Do not install near sources of heat.

Using specific kits, the indoor unit can be paired with other Immergas products and installed inside an outdoor wall using the specific 
Solar Container recessed frame or mounted on an indoor wall in the Domus Container.

Pay attention not to generate sparks as follows:
–  Do not remove the fuses while the unit is on.
–  Do not unplug the unit while it is on.
It is recommended to install the outlet high up. Lay the cables in such a way that they do not get 
tangled.

Installing the wall recessed frame kit must guarantee the indoor unit stable, efficient support.

The recessed frame kit ensures appropriate support only if installed correctly (according to the rules of good practice), following the in-
structions on its instructions leaflet.
The recessed frame for the indoor unit is not a supporting structure and must not replace the wall removed. It is necessary to position the 
boiler inside the wall.
For safety reasons against any leaks it is necessary to plaster the housing compartment of the indoor unit in the brick wall.

Wall mounting of the indoor unit must guarantee stable and efficient support for the genera-
tor.

The plugs (standard supply) are only to be used to fix the indoor unit to the wall; they only ensure adequate support if inserted correctly 
(according to technical standards) in walls made of solid or semi-hollow brick or block. In the case of walls made from hollow brick or 
block, partitions with limited static properties, or in any case walls other than those indicated, a static test must be carried out to ensure 
adequate mount.