Elica Ikona BL MAT/A/60 - Инструкция по эксплуатации - Страница 37

36 

• Never use the hood without effectively 
mounted grids. 

• The hood must NEVER be used as a 
support surface unless specifically 

indicated. 

• Use only the fixing screws supplied with 
the product for installation or, if not 

supplied, purchase the correct screws type. 

• Use the correct length for the screws 
which are identified in the Installation 

Guide. 
• In case of doubt, consult an authorized 

service assistance center or similar 

qualified person.  

 WARNING! 

Do not use with a 

programmer, timer, separate remote 

control system or any other device that 
switches on automatically. 

  Electrical connection 

The mains power supply must correspond 

to the rating indicated on the plate situated 
inside the hood. If provided with a plug 

connect the hood to a socket in compliance 

with current regulations and positioned in 
an accessible area, after installation. If it 

not fitted with a plug (direct mains 
connection) or if the plug is not located in 

an accessible area, after installation,  apply 

a double pole switch in accordance with 
standards which assures the complete 

disconnection of the mains under 

conditions relating to over-current category 
III, in accordance with installation 

instructions. 

WARNING!

 Before re-connecting the 

hood circuit to the mains supply and 

checking the efficient function, always 

check that the mains cable is correctly 
assembled. 

Installation 

• The minimum distance between the 

supporting surface for the cooking 

equipment on the hob and the lowest part 
of the range hood must be not less than 

50cm from electric cookers and 70cm from 

gas or mixed cookers. 
If the instructions for installation for the gas 

hob specify a greater distance, this must be 
adhered to. 

• This appliance is marked according to the European directive 
2012/19/EC - UK SI 2013 No.3113 on Waste Electrical and 
Electronic Equipment (WEEE).  
• By ensuring this product is disposed of correctly, you will help 
prevent potential negative consequences for the environment and 
human health, which could otherwise be caused by inappropriate 
waste handling of this product. 

• The symbol 

 on the product, or on the documents 

accompanying the product, indicates that this appliance may not 
be treated as household waste. Instead it should be taken to the 
appropriate collection point for the recycling of electrical and 
electronic equipment. Disposal must be carried out in accordance 
with local environmental regulations for waste disposal. 
• For further detailed information regarding the process, collection 
and recycling of this product, please contact the appropriate 
department of your local authorities or the local department for 
household waste or the shop where you purchased this product. 
 
Appliance designed, tested and manufactured according to: 
• Safety: EN/IEC 60335-1; EN/IEC 60335-2-31, EN/IEC 62233. 
• Performance: EN/IEC 61591; ISO 5167-1; ISO 5167-3; ISO 
5168; EN/IEC 60704-1; EN/IEC 60704-2-13; EN/IEC 60704-3; ISO 
3741; EN 50564; IEC 62301. 
• EMC: EN 55014-1; CISPR 14-1; EN 55014-2; CISPR 14-2; 
EN/IEC 61000-3-2; EN/IEC 61000-3-3. Suggestions for a correct 
use in order to reduce the environmental impact:  Switch ON the 
hood at minimum speed when you start cooking and kept it 
running for few minutes after cooking is finished. Increase the 
speed only in case of large amount of smoke and vapor and use 
boost speed(s) only in extreme situations. Replace the charcoal 
filter(s) when necessary to maintain a good odor reduction 
efficiency. Clean the grease filter(s) when necessary to maintain a 
good grease filter efficiency. Use the maximum diameter of the 
ducting system indicated in this manual to optimize efficiency and 
minimize noise.