Beurer BF1000 - Инструкция по эксплуатации - Страница 34

34

  NOTE:

– When replacing the batteries, use batteries of the same type, make and capacity.

– Do not use rechargeable batteries.

– Use batteries free from heavy metals.

13. Cleaning and maintaining the device

The device should be cleaned from time to time.

This should be done using a damp cloth and, if necessary, a small amount of detergent. 

  IMPORTANT

– Never use harsh solvents or cleaning products!

– Never submerge the device in water!

– Do not clean the device in the dishwasher.

14. Disposal

Empty, completely flat batteries must be disposed of through specially designated collection boxes, recy-

cling points or electronics retailers. You are legally required to dispose of the batteries.

The codes below are printed on batteries containing harmful substances: 

Pb = Battery contains lead, Cd = Battery contains cadmium, Hg = Battery contains mercury.

For environmental reasons, do not dispose of the device in the household waste at the end of its service 

life. Dispose of the device at a suitable local collection or recycling point in your country. 

Dispose of the device in accordance with EC Directive – WEEE (Waste Electrical and Electronic 

Equipment). If you have any questions, please contact the local authorities responsible for waste 

disposal.

Dispose of packaging in an environmentally friendly manner.   

20

PAP

15. What if there are problems?

If the scale encounters an error during measurement, the following is displayed:

Display 

Cause

Solution

ERROR:_OVERLOAD 

Maximum weight capacity of 200 kg 

exceeded.

Loads must be limited to 200 kg.

LOW_BATTERY 

Batteries are nearly flat. 

Replace the batteries (see section on 

changing the batteries).

MEMORY_FULL 

30 measurements have been stored. 

Transfer the measured values.

ERROR:_CONTACT 
ERROR

The electrical resistance between the 

electrodes and the soles of the feet is 

too high (e.g. with very hard skin).

Repeat the measurement barefoot. 

Dampen the soles of your feet slightly. If 

necessary, remove hard skin on the soles.

Hold the hand electrodes with the fingers 

behind and the balls of the thumb in front.

ERROR:_DATA

The BIA measurement was success-

ful, but the fat percentage is outside 

the measurable range (less than 3% or 

greater than 65%).

Please repeat the measurement barefoot, 

or with the soles of the feet lightly damp-

ened if necessary. If necessary, change 

your set activity level.

Empty display

Batteries are completely flat.

Replace the batteries (see section on 

changing the batteries).

The batteries are not inserted properly.

Check for correct polarity, (see “Initial use” 

-> “Changing the batteries”).