Fulgor Milano FCLVSD 150 TC - Инструкция по эксплуатации - Страница 52

EN

20

Problem

Cause

Solution

Sealing is not optimal

• The level of sealing set is not correct 

for the type of bag being used.

• Many consecutive cycles were 

performed with sealing.

• The bag is larger than the sealing 

bar.

• The edge of the bag  was not 

positioned correctly.

• The edge of the bag is dirty.

• The counter-pressure rubber and the 

sealing bar are dirty.

• The counter-pressure rubber and the 

sealing bar are damaged.

• Repeat the cycle by adjusting the 

sealing level.

• Wait at least 2 minutes between 

one cycle and another to allow the 

sealing bar to cool.

• Use a suitable bag.

• Position the edge of the bag 

centrally and so that it protrudes 

approximately 2 cm from the sealing 

bar.

• Avoid the edge forming creases 

close to the sealing bar.

• When the product is inserted, turn 

the edge of the bag over so that the 

outer part remains clean.

• Clean the sealing bar and the 

counter-pressure rubber.

• Contact the Technical Support 

service.

Problem

Cause

Solution

Flashes 

• The pump has absorbed humidity 

and impurities.

• Start the DRYING CYCLE.
• Take more care to cool products to 

3°C and/or respect the liquid part 

quantities inserted into the bag or 

container.