Fulgor Milano FCLVSD 150 TC - Инструкция по эксплуатации - Страница 51

EN

19

13 - Troubleshooting

Most of the problems that occur during daily use of the packaging machine can be eliminated personally. The following table 

serves as a support.

Request the intervention of Technical Assistance if it is not possible to solve the problem personally.

Problem

Cause

Solution

The packaging machine does not 

come out of the drawer.

• Guides “push to open” system 

jammed.

• Coiled power cable jammed.

• Contact the installer.

• Contact the installer.

The packaging machine does not 

switch on

• The packaging machine is not 

powered.

• The power plug is not inserted in the 

socket.

• Check that there is power to the 

socket used.

• Insert the plug of the power supply 

into the socket.

The packaging machine is off.

• No electrical power.

• Electronic fault.

• Disconnect the electrical power 

supply.

• Contact  the  technical support 

service.

The keys do not react to the commands. • The surface of the control panel is 

dirty or wet.

• Clean and dry the surface of the 

control panel.

The lid doesn’t open.

• A cycle is running.

• There is no indicator light illuminated 

on the panel

• It is normal that during the operating 

cycles the lid remains closed. Wait 

for the end of the cycle or press 

STOP

 to interrupt the cycle and 

emptythe tray.

• During the cycle there is no electrical 

power. NEVER ATTEMPT TO OPEN 

THE LID. Restore the power supply 

and wait for decompression of the 

tray.

Too much air remains in the sealed 

bag.

• The bag is not suitable to the 

dimensions of the product to be 

packaged.

• The level of vacuum chosen is too 

low.

• The product is liquid.

• Use a bag of suitable size.

• Repeat the cycle with a higher level 

of vacuum.

• It is normal that with a liquid product, 

some air bubbles remain inside.

The sealing bar is raised but sealing is 

not performed.

• The protection device of the sealing 

bar is activated.

• The sealing bar is broken.

• In the bottom right of the packaging 

machine there are 2 buttons (A) that 

restore the internal protections. Press 

the keys to restore the protections. If 

the fault recurs contact the Technical 

Support service.

• Contact the Technical Support 

service.