Газонокосилки STIGA TWINCLIP 950 SQ AE 294513898/ST1 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
EN - 12
General cleaning
and inspection
After each use
par. 7.3
Checking for any damage to
the machine. If necessary,
contact the authorised
service centre.
After each use
-
Cleaning the air filter
Once a month
par. 7.5
Replacing the cutting means
-
par. 8.1 ***
* Refer to the battery/battery charger manual.
** The operation must be carried out by your Dealer or a specialised Authorised Service Centre
*** Operation to be performed at the first signs of any malfunction
14. PROBLEM IDENTIFICATION
If problems persist after having performed the above operations, contact your dealer.
PROBLEM
PROBABLE CAUSE
SOLUTION
1.
After pressing the start
-
er button, the display
does not come ON.
Safety key is not inserted or
is inserted incorrectly.
Insert the key (par. 6.3).
The safety key is not in "OFF" position.
Turn the safety key to "ON" position (par. 6.3).
Battery is not inserted or is
inserted incorrectly.
Open the hatch and check that the battery
is fitted in its housing correctly (par. 7.2.3).
Low battery.
Check the battery status and recharge
if necessary (par. 7.2.2).
Incorrect battery combination.
Check if the battery combination is
correct, following the instructions
supplied in the "Technical data" table.
2.
After pressing the start
-
er button, the display
does not come ON
and the machine sets
off a sound signal.
Internal motor anomaly.
Remove the safety key and contact
the Authorised Service Centre for
checks, replacements or repairs.
3.
The motor shuts down
whilst working.
Battery is not inserted correctly.
Open the hatch and check that the battery
is fitted in its housing correctly (par. 7.2.3).
Low battery.
Check the battery status and recharge
if necessary (par. 7.2.2).
Obstructions that prevent
rotation of the cutting means.
Remove the safety key, wear work gloves and
remove grass or debris from the lower part of
the machine and/or from the discharge chute.
4.
The danger LED lights
up on the display (Fig.
24.A) and the machine
emits a sound signal
Cutting means blocked.
Turn the machine off, remove the
safety key and wear work gloves.
Check and eventually remove any obstructions
in the machine lower side (par. 7.3.2) that
prevent rotation of the cutting means.
If the problem continues, contact the
Authorised Service Centre for checks,
replacements or repairs (par. 8.1).
Machine fault.
Remove the safety key and contact
the Authorised Service Centre for
checks, replacements or repairs.
Drive motor over current for heavy
working conditions (drive under stress).
–
Make sure that the wheels are not
blocked. Clean as needed.
–
Check the slope of the land you
are working on (par. 6.4.1).
