Ryobi ONE+ OLM1834H 5133002369 - Инструкция по эксплуатации - Страница 5

Ŷ

Stop the mower motor and remove isolator key and/ 
or disconnect from the power supply, make sure that 
all moving parts have come to a complete stop for the 
below cases:

Ɣ

whenever you leave the product unattended 
(including disposal of grass clippings).

Ɣ

before cleaning a blockage or unclogging discharge 
chute

Ɣ

before checking, cleaning or working on the product 

Ɣ

after striking a foreign object; inspect the product 
for damage and make repairs as necessary before 
restarting and operating the product.

Ɣ

before removing the grass box or opening the grass 
discharge chute cover.

Ɣ

If the product starts to vibrate abnormally (check 
immediately)

–

inspect for damage, particularly the blades

–

replace or repair any damaged parts

–

check for and tighten any loose parts

Ŷ

Avoid holes, ruts, bumps, rocks, property stakes, or 
other hidden objects. Uneven terrain could cause a slip 
and fall accident.

OVERLOAD PROTECTION DEVICE

The product has an overload protection device. When 
overloading is detected, the product will automatically 
switch off.
If the product stops working, release all handle bar switches 
for a few seconds in battery mode of operation or let motor 
cool down for a few minutes in AC mode of operation.  
Follow normal switch on procedure to activate the mower 
again. The motor should again start working.
This applies to both AC and Battery mode of operation.
If the protection device operates often, raise the height of 
the cut, check the blade is not damaged. If it still occurs, 
return to an authorised service centre for investigation.

INTENDED USE

The product is only intended for use outdoors.
The product is designed for domestic lawn mowing. The 
cutting blade should rotate approximately parallel to the 
ground over which it is being wheeled. All four wheels 
should touch the ground while mowing. It is a pedestrian 
controlled walk behind mower designed to be pushed by 
hand.
The product should never be operated with the wheels off 
the ground; it should not be pulled or ridden on. It should 
not be used to cut anything other than domestic grass 
lawns.

RESIDUAL RISK

Even when the product is used as prescribed, it is still 
impossible to completely eliminate certain residual risk 
factors. The following hazards may arise in use and the 
operator should pay special attention to avoid the following: 

Ŷ

Injury caused by vibration. Always use the right tool for 
the job, use designated handles and restrict working 
time and exposure. 

Ŷ

Exposure to noise can cause hearing injury. Wear ear 
protection and limit exposure.

Ŷ

Contact with blades

Ŷ

Injury from thrown objects

TRANSPORTATION AND STORAGE

Ŷ

Stop the product, remove the isolator key and the 
battery or disconnect from the power supply, make sure 
that all moving parts have come to a complete stop, and 
allow it to cool before storing or transporting.

Ŷ

Clean all foreign material from the product. Store it in a 
cool dry and well-ventilated place that is inaccessible 
to children. Keep away from corrosive agents such 
as garden chemicals and de-icing salts. Do not store 
outdoors.

Ŷ

For transportation, secure the product against 
movement or falling to prevent injury to persons or 
damage to the product.

 WARNING

Use extreme caution when lifting or tilting the product 
for maintenance, cleaning, storage or transportation, the 
blade is sharp, keep all body parts away from the blade 
whilst it is exposed.

MAINTENANCE

 WARNING

Use only original manufacturer’s replacement parts, 
accessories and attachments. Failure to do so can cause 
injury, poor performance and may void your warranty.

 WARNING

Servicing requires extreme care and knowledge 

DQG VKRXOG EH SHUIRUPHG RQO\ E\ D TXDOL¿HG VHUYLFH

technician. For service we suggest you return the 
product to your nearest authorised service centre for 
repair. When servicing, use only identical replacement 
parts.

Ŷ

Remove the isolator key, and the battery pack, 
disconnect from the power supply, before any cleaning 
or maintenance task.

Ŷ

You may make adjustments and repairs described 
here. For other repairs, contact the authorised service 
agent.

Ŷ

Check the grass box frequently for wear or deterioration.

Ŷ

After each use, clean the product with a soft dry cloth. 
Any part that is damaged should be properly repaired or 
replaced by an authorised service centre.

Ŷ

Check all nuts, bolts and screws at frequent intervals 
for proper tightness to ensure the product is in safe 
working condition.

Ŷ

Be careful during adjustment of the product to prevent 
entrapment of the fingers between moving blades and 
fixed parts of the product.

3

 English 

|

EN

FR

DE

ES

IT

NL

PT

DA

SV

FI

NO

RU

PL

CS

HU

RO

LV

LT

ET

HR

SL

SK

BG