Braun MultiQuick 9 HB901AI-MQ9195XLI - Инструкция по эксплуатации - Страница 24

24

• 

Then put on the lid (11a) until it engages with a 
click.

• 

Insert the motor part (4) into the coupling (11b) 
until it locks.

• 

Plug in the appliance and insert the pusher (11c) 
in the feed tube (11d).

• 

To operate the food processor, switch on the 
appliance. During processing, hold the motor 
part with one hand and the food processor bowl 
on the handle.

• 

When chopping is complete, unplug and press 
the EasyClick Plus  release buttons (5) to detach 
the motor part.

• 

Press the lid latch (11e) to lift up the lid. Then 
separate the lid from splash guard.

• 

Carefully take out the blade before pouring out 
the contents of the bowl. To remove and unlock 
the blade, slightly turn it then pull it off.

Caution

• 

Do not use the food processor accessory to 
chop extremely hard foods, such as unshelled 
nuts, ice cubes, coffee beans, grains or hard 
spices e.g. nutmeg. Processing these foods 
could damage the blades.

• 

Never place the food processor bowl in the 
microwave oven.

Using the blade (11i), you may also mix pancake 
batter based on up to 500 g of flour.

Recipe Example: Pancake Batter
750 ml milk
500 g plain flour
4 eggs

• 

Pour milk into the bowl, then add flour and finally 
the eggs.

• 

Using full speed, mix the batter until smooth.

Heavier batters or doughs must not be prepared 
with the knife. Use the Dough Tool or Kneading 
hook (11k/11l) for heavier batters and doughs.

Dough Tool and Kneading Hook (E)

Figure E also applies (depending on model) for the 
use of the dough tool (11k) and the kneading hook 
(11l). 

The dough tool is ideal for kneading and mixing 
different doughs such as yeast or pastry and mixing 
sponge mixtures.

The kneading hook is ideal for kneading different 
dough types such as yeast or pastry.

Refer to the Processing Guide Kneading E for 
maximum quantities, recommended times and 
speeds.

Assembly and Operation

• 

Place the dough tool / kneading hook on the 
center pin of the bowl (11g). Press it down and 
give it a turn so that it locks into place.

• 

Fill the bowl with flour (max. 500 g), then add the 
other ingredients except the liquids.

• 

Turn the appliance on at maximum speed. 

• 

Add liquids through the feed tube while the motor 
is running. 
NOTE: Maximum kneading time: 1 minute – then 
allow the motor to cool down for 10 minutes.

Recipe Example: Pizza dough
500 g plain flour
1 tsp. salt
1 tsp. dried yeast
10 tbsp. olive oil
300 ml water (lukewarm)

• 

Put all ingredients except water into the bowl and 
start kneading.

• 

Add water through the feed tube while the motor 
is running.

Recipe Example: Sweet Pastry
500 g plain flour
340 g unsalted butter (cold/hard, small pieces)
160 g sugar
2 vanilla sugar
2 small egg
2 pinch salt

• 

Put butter and sugar into the bowl and start 
kneading. For good results use cold butter.

• 

Add flour and the rest of the ingredients.

• 

Dough will become too soft from over kneading. 
Stop kneading shortly after dough has formed a 
ball.

• 

Cool down the dough in the refrigerator for half 
an hour before proceeding.

Recipe Example FPXL: Cake Batter
500 g plain flour
200 g sugar
200 g unsalted butter 200 g unsalted butter (cold/
hard, small pieces)
3 eggs
1 vanilla sugar
1 baking powder
200 ml milk

• 

Add flour and all other ingredients except the 
milk into the bowl and start kneading.

• 

Gradually add milk while running until uniform 
mass has formed.

Recipe Example Dicer: Sweet dough
500 g plain flour
80 g sugar
80 g unsalted butter
1 egg
7 g yeast
375 ml milk

• 

Add flour and all other ingredients except the 
milk into the bowl and start kneading.

• 

Gradually add milk while running until and slowly 
knead the mass dough until it forms a ball that no 
longer sticks to the bowl.

• 

Let the dough rise in a warm place for 2 hours.

5722112384_HB901-MQ91-75-87-95 INT.indd   24

01.07.20   13:47