MERCUSYS MW306R N300 3xFE LAN 1xFE WAN - Инструкция по эксплуатации - Страница 36

27

Chapter 4

•  Network Destination

 - The destination IP address that you want to assign to a 

static route. This IP address cannot be on the same subnet with the WAN IP or 
LAN IP of Router A. In the example, the IP address of the company network is the 
destination IP address, so here enter 172.30.30.1.

•  Subnet Mask

 - The Subnet Mask determines which portion of an IP address is the 

network portion, and which portion is the host portion.

•  Default Gateway

 - The IP address of the gateway device to which the data packets 

will be sent. This IP address must be on the same subnet with the router’s IP which 
sends out data. In the example, the data packets will be sent to the LAN port of 
Router B and then to the Server, so the default gateway should be 192.168.1.2.

•  Interface 

- Determined by the port (WAN/LAN) that sends out data packets. In the 

example, the data are sent to the gateway through the LAN port of Router A, so 

LAN 

should be selected.

•  Description 

-  Enter a description for this static routing entry.

5. 

Click 

SAVE

.

6. 

Check the 

Routing Table

 below. If you can find the entry you’ve set, the static routing is 

set successfully.

4. 3.  Wireless

4. 3. 1.  Wireless Settings

1. Visit 

http://mwlogin.net

, and log in with the password you set for the router.

2. Go to 

Advanced 

> 

Wireless 

> 

Wireless Settings

. 

3. 

Configure the wireless settings for the wireless network and click 

SAVE

.