Проигрыватели Sharp DV-NC70RU - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
95
GB
Troubleshooting
■
VCR/DVD
■
VCR
Problem
•
No power
•
The Remote does not wor k.
•
No picture
•
DEW
Suggested Solution
•
Is the power cord connected properly?
•
Is the power cord firmly plugged into the power outlet?
•
One of the safety mechanisms may be operating. In this event,
unplug the Product from the power outlet briefly and then plug it in
again.
•
Are the batteries loaded correctly?
•
Are the batteries flat?
•
Is the signal emitter on the Remote pointing at the Product?
•
Is the Remote too far from the Product, or is there any obstacle
between the Remote and the Product?
•
Did the
VCR/DVD CHANGE Switch
change correctly?
•
Did the
VCR/DVD SELECTOR
change correctly?
•
See page 2 for information (Condensation).
Suggested Solution
•
Cassette erasure protection tab has been removed. Use a different
cassette or place adhesive tape over the tab opening.
•
Check if a cassette is loaded.
•
Cassette erasure protection tab has been removed. Use a different
cassette or place adhesive tape over the tab opening.
•
Make sure all the cables are correctly connected.
•
Make sure the Product power cord is properly plugged in.
•
Set the COLOUR MODE, NTSC MODE, and SYSTEM modes to
match the broadcast system and TV.
•
Press
CH
'
/
"
to adjust the tracking or try a different cassette.
•
The heads may be contaminated with condensed moisture or
magnetic coating from the video tape. (If this is the case, the
heads need to be cleaned. Ask the retailer or a Sharp approved
service centre.)
This Product has a built-in full auto head cleaning mechanism,
however, there are some environments in which head cleaning
cannot be carr ied out completely.
•
Make sure the Product is not in pause/still mode.
•
Make sure the tape has not reached the beginning or end.
•
Make sure the TV is set to the same channel as the Product radio
frequency converter output channel adjuster (CHANNEL).
•
Check all connecting cables.
•
Set the COLOUR MODE, NTSC MODE, and SYSTEM modes to
match the tape and TV.
Problem
•
VCR does not record.
•
Cassette is automatically ejected
when pressing
Æ
Æ
Æ
Æ
Æ
REC
or
TIMER
ON/OFF
.
•
No colour or poor TV picture during
normal viewing.
•
Snowy picture appears on TV during
playback.
•
No tape movement.
•
No picture appears or colour is not
correct during playback.
The following problems do not always denote a malfunction of this Product. Perform the checks listed below
before calling service.
OTHER
INFORMA
TION
