Мойки высокого давления Karcher CB 1 28 Eco - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
-
17
Faults without display
Fault
Possible cause
Remedy
of whom
Cleaning effect inad-
equate
None or too little detergent, none or too little
air pressure in the supply line, worn brushes
Check filling level of the detergent; if necessary fill up;
vent dosing pumps. Clean detergent suction, check
detergent supply lines for damage, check brushes
and if necessary replace.
Operator
Too little water or
none is coming out of
the jets.
Dirt catcher is blocked, water pressure insuffi-
cient, jets blocked, magnet valve or supply line
defective
Clean dirt catcher, check water supply pressure and
pumps, clean jets with compressed air, service mag-
net valves and supply lines (water und electricity) if
necessary.
Operator
Water still comes out
of the the jets after
the end of the wash
Magnet valve dirty
Clean magnet valves.
Customer
Service
Drying insufficient
Too little or too much drying aid, false drying
aid, none or too little air pressure
Increase or decrease dosage, check filling level of the
detergent, clean suction filter, vent dosing pump, use
original drying aid from Kärcher, check function of the
blow-out drier.
Operator
Wheel wash brush
does not turn.
Contact pressure is too high
Reduce contact pressure at the pressure lessener for
wheel wash (Diag. 1).
Operator
Move wheel wash
brush slowly or not out
None or too little air pressure
Check air pressure (about. 0.275 MPa (2.75 bar)), if
necessary adjust, increase contact pressure at the
pressure lessener for wheel wash (Fig. 1).
Operator
Wheel wash brush
moves out on the
false side
Light barriers dirty
Clean light barriers, if necessary check setting.
Operator/
Customer
Service
Brushes dirty fast
Shampoo dosage too low
Adjust shampoo, check water amount, adjust if nec-
essary.
Operator
Jet pipes of the un-
derfloor wash oscil-
late too slowly/fast or
not at all.
None or too little air pressure
Check air pressure in the supply line, if necessary ad-
just.
Operator
Oscillating unit strongly dirtied.
Clean oscillating unit.
Operator/
Customer
Service
Throttles falsely set.
Reset throttles.
Operator/
Customer
Service
Plant without function Fault in the voltage supply
See to fault-free voltage supply according to connec-
tion values.
Operator/
Electri-
cians
Portal is driven out
beyond limit switch
for the ends of the
drive-rails
Limit switch falsely set
Check distance between limit switch and switch flag
(nominal: 4mm).
Operator/
Customer
Service
36
EN
