La Pavoni LPSGEV03EU - Инструкция по эксплуатации - Страница 30

26

27

EN

6–2. CLEANING THE GROUP HEAD AND 

SHOWER SCREENS

•

Remove the filter holder from the 

group head and clean the group's 

gasket using the brush (

16) provided.

•

Place the blind filter (

27) provided in 

the filter holder (

24-25-26)

•

Add a spoonful of coffee machine 

cleaning powder and insert the filter 

holder into the group head.

•

Use the group head control (

15) to 

start dispensing and stop delivery after 

approximately 15-20 seconds.

•

Start and stop delivery several times 

until clean water is dispensed, in 

order to remove coffee and limescale 

deposits.

•

Remove the blind filter (

27) and start 

dispensing several times in order to 

rinse the group head and eliminate 

any residues from the shower screens 

and the group head. 

If hot water has remained in 

the pipes for a long time, we 

recommend that you allow 

water to flow out to remove any 

deposits.

6–3. CLEANING THE FILTERS AND 

FILTER HOLDERS

•

Regularly check the holes in the 

filters in order to remove any coffee 

deposits.

•

Place approximately one litre of 

boiling water and four teaspoons of 

coffee machine cleaner in a suitable 

container. Immerse the filters and 

filter holders in the solution for 20-30 

minutes. Then rinse thoroughly under 

running water.

6–4. CLEANING THE LOWER DRIP TRAY

Remove the drip tray grid (

8) and 

the drip tray (

13

). Remove any coffee 

residues from it by rinsing it under 

running water.

6–5. CLEANING THE OUTSIDE OF THE 

MACHINE

To keep the outer surface of the coffee 

machine in good condition, it should 

be cleaned regularly after use. Let the 

appliance cool down first. Clean with a 

soft, damp cloth.

6–6. REPLACING THE GROUP HEAD 

GASKET (Fig. 7)

If coffee leaks from around the edges of 

the filter holder (L) when it is dispensed, 

it may be due to an obstruction in the 

delivery hole of the filter-holder, in 

which case the hole should be cleaned.

If the problem persists or if the filter 

holder moves significantly beyond 

the centre of the group head when it 

is being fitted, the group head gasket 

should be replaced.

To replace it, proceed as follows:

•

Make sure that the machine is 

switched off and disconnect the power 

cable.

•

Remove the gasket (I) and the shower 

screen (M), using a flat screwdriver as 

a lever.

•

After having removed the gasket and 

shower screen, clean the seat properly 

before installing the new components.

•

Once the new components have 

been installed, insert the filter holder, 

without the filter, into the group head 

and move it in order to seat the gasket.