La Pavoni LPSGEV03EU - Инструкция по эксплуатации - Страница 25

20

21

EN

controller

30. Service boiler PID temperature 

controller

31. Service boiler ON / OFF switch

32. Service boiler ON/OFF indicator light

33. Pressure gauge - BPPC (Brewing 

Pressure Profiling Control) 

34. “BPPC” adjustment lever*

*standard on LPSGEG03 models

**standard on LPSGEV03 models

4. STARTING THE MACHINE FOR 

THE FIRST TIME 

4–1. CONNECTING TO THE WATER 

SUPPLY

The LPSGEG03 and LPSGEV03 machines 

can either be used with a water tank (

2) 

or connected to the mains water supply 

using the hose provided (

17). 

In order to use the machine with a 

water tank (

2

), the switch (C) has to be 

in position “I”” (this should be done with 

the machine switched off) (Fig. 1-2).

To use the machine connected to the 

water supply:

•

Place the switch (C) to position “II” 

(this should be done with the machine 

switched off) (Fig. 1-2).

•

Connect the hose (

17

) to the fitting (D) 

located under the machine and then 

connect it to the water supply (Fig. 1). 

•

It is recommended that you 

install a water softener on the 

machine water supply system.

•

Make sure that the water in 

the water supply that you will 

be connecting the machine to is 

potable.

•

This appliance should be 

connected to the water supply 

in compliance with the national 

Legislation of the country in which 

it is used.

•

The maximum inlet pressure 

to the machine from the water 

supply must not exceed 0.65 MPa. 

If it is higher than 0.5 MPa (5 bar), 

it is recommended that you install 

a balanced pressure regulator for 

high pressures.

4–2. ELECTRICAL CONNECTION AND 

FIRST USE

To start the espresso coffee machine, 

carefully follow the instructions below:

•

Open the package, take out the 

machine and make sure that it is not 

damaged. 

•

Place the machine on a level surface, 

remove the cover, take out the water 

tank (

2) and rinse it.

•

Fill the tank with clean water, put it 

back in its seat, and insert the silicone 

tubes. Close the machine cover.

•

If you connect the machine to the 

water supply, make sure that the water 

supply tap is open before switching on 

the machine.

•

Water can be drained directly into 

a drainage outlet by removing the 

plug (A) from the drip tray (

13) and 

connecting the silicon tube (

28) to the 

tray (B) (Fig. 1).

Before connecting the machine, 

make sure that the mains power 

voltage is the same as the one 

indicated on the data plate 

located under the base of the 

machine.

•

Insert the plug into the power socket.

•

Before starting the machine, place the 

filter holder (

12) into the group head 

(

11); place a container under the group 

head and move the lever (

15) upwards 

in order to fill the coffee boiler.

•

Turn on the machine by placing the 

on / off switch (

1) to position "I". Wait