Газонокосилки Viking МВ 2.2 R 63570113402 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
37
DE
FR
NL
IT
ES
PT
NO
SV
FI
DA
PL
HU
SR
HR
EN
0478 111 9926 A - EN
Starting procedure when the engine is
warm:
●
The starting procedure is the same as
when the engine is cold.
Only for MB 2 R:
It is not necessary to press the
primer (1).
11
.2 Stopping the engine
●
Release the motorstop lever (1).
The engine and blade come to a
standstill within 3 seconds.
11
.3 Self-propulsion (MB 2 RT)
1
Switching on self-propulsion
●
Start the engine. (
●
Pull the self-propulsion
lever (1) to the handlebar
and hold.
Self-propulsion is activated and the lawn
mower moves forwards.
2
Switching off self-propulsion
●
Release the self-propulsion lever (1).
Self-propulsion is deactivated and the
lawn mower comes to a standstill.
The engine and blade continue to run.
Annual service by the specialist dealer:
The lawn mower should be inspected once
annually by a specialist dealer. VIKING
recommends VIKING specialist dealers.
1
2.
1
Cleaning the machine
Maintenance interval:
After each use.
Place the machine in the cleaning
position.
●
Open the quick-clamping devices (1)
and fold down the handlebar (2) to the
rear.
●
Lift up the machine at the front and
place in the cleaning position as shown.
1
2.2 Checking blade wear
Maintenance interval:
Before each use.
Checking procedure
●
Place the machine in the cleaning
position. (
●
Clean the blade (1) and check it for
damage (notches or cracks).
●
Use a slide calliper (2) to measure the
blade thickness (A) at several points.
●
Measure the permissible grinding (B).
Place a ruler (3) against the front blade
edge as shown for this purpose.
Avoid damage to the machine.
The primer must no longer be
pressed when the engine is warm.
It should be remembered, however,
that the engine can cool down
rapidly in very cold weather.
Note
The MB 2 RT model features front-
wheel drive.
1
0
11
1
2. Maintenance
Risk of injury!
Carefully read the section "For your
safety" (
4.), particularly the
subsection "Maintenance and
repairs" (
4.7), and follow all
safety instructions exactly before
performing any maintenance or
cleaning operations on the
machine.
Allow the machine too
cool and detach the
spark plug socket before
performing any
maintenance or cleaning
operations.
Risk of injury!
Stop the engine, allow the machine
to cool and detach the spark plug
socket.
Empty the fuel tank (run empty)
before placing the machine in the
cleaning position.
1
2
Risk of injury!
Blades are subjected to differing
degrees of wear depending on the
location and duration of use. If you
use the machine on sandy ground
or use it frequently under dry
conditions, the blade will be
subjected to greater loads and will
wear more quickly than the
average.
A worn blade may break off and
cause serious injuries. The
instructions for blade maintenance
must therefore always be
observed.
1
3
