Sony CCD-TRV408E - Инструкция по эксплуатации - Страница 152

152

— Tr o u b l e sh o o t i n g  —

En g l i sh

Ty p e s o f  t ro u b l e  a n d  t h e i r  so l u t i o n s

If you run into any problem using your camcorder, use the following table to troubleshoot the

problem. If the problem persists, disconnect the power source and contact your Sony dealer or local

authorised Sony service facility. If “C:

ss

:

ss

” appears on the screen, the self-diagnosis display

function has worked. See page 158.

I n  t h e  r e co r d i n g  m o d e

Sympt om

Cause and/ or Correct ive Act ions

• The POWER switch is set to OFF (CHG) or PLAYER.

c

Set it to CAMERA. (p. 29)

• The tape has run out.

c

Rewind the tape or insert a new one. (p. 27, 43)

• The write-protect tab is set to expose the red mark.

c

Use a new tape or slide the tab. (p. 28)

• The tape is stuck to the drum (moisture condensation).

c

Remove the cassette and leave your camcorder for at least
1 hour to acclimate. (p. 179)

• While being operated in CAMERA mode, your camcorder has

been in the standby mode for more than 3 minutes*

1)

/

5 minutes*

2)

.

c

Set the POWER switch to OFF (CHG) and then to CAMERA

again. (p. 29)

• The battery pack is dead or nearly dead.

c

Install a fully charged battery pack. (p. 18, 19)

• The viewfinder lens is not adjusted.

c

Adjust the viewfinder lens. (p. 34)

• STEADYSHOT is set to OFF in the menu settings.

c

Set it to ON. (p. 137)

• 16:9WIDE is set to ON in the menu settings.*

1)

c

Set it to OFF. (p. 137)

• The wide mode is set to 16:9FULL.*

4)

c

Set it to OFF. (p. 137)

• The setting is the manual focus mode.

c

Press FOCUS to return to the autofocus mode. (p. 70)

• Shooting conditions are not suitable for autofocus.

c

Adjust to focus manually. (p. 70)

• The video heads may be dirty.

c

Clean the heads using the Sony V8-25CLD cleaning cassette

(optional). (p. 180)

• The LCD panel is open.

c

Close the LCD panel. (p. 31)

START/STOP does not operate.

The power goes off.

The image on the viewfinder screen

is not clear.

The autofocusing function does not

work.

The SteadyShot function does not

work.*

3)

The picture does not appear in the

viewfinder.

The 

x

 indicator flashes in the

viewfinder.*

2)