Fulgor Milano FCLH 9008 ID WT BK - Инструкция по эксплуатации - Страница 38

EN

16

4 - Installation instructions

Installation

these instructions are aimed at qualified fitters as a guide to 

installation, adjustment and maintenance in compliance with 

the laws and standards in force. The operations must always 

be carried out with the appliance disconnected from the 

electricity supply.

Positioning

The appliance is made to be fitted into a counter top, as show 

in the figures at page 18. Apply the sealant supplied around 

the whole perimeter of the hob. Installation over an oven is not 

recommended, but if this is necessary, check that: 
• the oven has an efficient cooling system;
• there is no passage of hot air from the oven to the hob;
• allow air passages as shown in the figure. 

Electrical connection

Before connecting to the electricity supply, ensure that: 
• the characteristics of the system are such as to satisfy that 

indicated on the registration plate applied to the bottom of 

the hob;

• the system has an effective earth connection compliant with 

the standards and laws in force. Connection to earth is 

compulsory by law. 

If the appliance has no cable and/or plug, use material 

suitable for the absorption indicated on the registration plate 

and for the working temperature. The cable must not reach a 

temperature higher than 50°C above room temperature in any 

point. 

For direct connection to the network it is necessary to fit an 

omnipolar switch of a suitable size to ensure disconnection 

of he network with a contact opening distance that allows 

complete disconnection in the conditions of the overtension 

category III, compliant with the installation regulations (the 

yellow/green earth wire must not be interrupted). 

The omnipolar socket or switch must be easy to reach when the 

appliance is installed. 

N.B.:
• The manufacturer declines all responsibility if the usual 

accident prevention standards and the above instructions 

are not observed. 

If the power cable is damaged, it must be replaced by the 

manufacturer or by the manufacturer’s technical servicing 

network, or by a similarly qualified operator, to prevent every 

possible risk.

VSee the power supply cables table, page 20.

List of errors displayed

In case of errors or malfunctions of the hob, a number of error 

codes may appear on the display.

The intervention must be performed by technical assistance 

and by a specialist technician.