Franke FHMA 755 4G DCL XS C - Инструкция по эксплуатации - Страница 9

– 9 –

FHMA 604 3G DC / FHMA 755 4G DC/DCL / FHMA 905 4G DCL / FHSM 604 3G DC

FHSM 604 4G / FHSM 755 4G DC / FHSM 905 4G DCL

EN

Replacing injectors

Not supplied injectors must be requested to 

the customer service.

Important:

 All the appliances are factory-set 

for natural gas (G20). If a different type of gas 

is to be used, change the injectors as follows:

– Remove the grids, burner caps and flame-

spreaders;

– Unscrew the injectors and replace them 

with those provided and suitable for the 

gas supply, making sure the marking 

matches that given in the table;

– Refit the flame-spreaders, burner caps 

and grids.

These burners do not require air adjustment.

7

 ø

Accessing the hob

To access the tray containing the functional 

parts, proceed as follows:

– Remove the grids, burner caps and flame-

spreaders;

– Remove the knobs, sliding them off their 

pins; 

– Remove the screws that fix the burners to 

the hob;

– Lift the hob.

Important:

 When converting the appliance to  

a different type of gas, place the corresponding 

sticker (supplied as an accessory) in the 

special space on the data plate. For operation 

with LPG (G30 or G31), the minimum flame 

adjustment screw must be fully screwed down. 

These appliances are supplied in cat. II 2H3+.

INTENDED USE

CAUTION: 

This appliance is for cooking 

purposes only. It must not be used for other 

purposes, for example room heating.

Z

Do not pull the appliance or the power 

cable to unplug it.

Z

Close the general gas supply cock when 

the hob is not in use.

 Risk of burns!

Z

Do not touch the pot grids during use.

Z

Do not touch the appliance with wet parts 

of the body.

Lighting the burners

The hob is lit with the control knobs. To light 

the burners, proceed as follows:

– Press and turn the required knob to the 

lighting and max delivery position.

– Keep the knob pressed down for  

3-4 seconds to allow the sparks to ignite 

the gas coming out the burner and to allow 

the thermocouple to heat up.

Then release the knob and, turning it 

anticlockwise, adjust the flame as required. 

If the flame does not stay lit, repeat the 

operation from step 1.