Elica NIKOLATESLA PRIME S BL/A/83 - Инструкция по эксплуатации - Страница 22

residue and ensure maximum hygiene levels.
For  a  more  complete  and  in-depth  clean,  the  bottom
collection channel can be completely removed.

● 

Cleaning the metal grille:

The  grille  must  be  washed  by  hand  with  hot  water  and
neutral  detergent,  then  dried  thoroughly  to  prevent
oxidation.

EXTRACTOR FAN MAINTENANCE

● 

Cleaning the extractor fan :

For  cleaning,  use 

ONLY

  a  cloth  moistened  with  neutral

liquid detergents.

DO NOT USE CLEANING UTENSILS OR TOOLS!

Avoid  the  use  of  products  containing  abrasives. 

DO  NOT

USE ALCOHOL!

● 

Grease filter maintenance:

Traps grease particles generated by cooking.

Must  be  cleaned  once  a  month  (or  when  indicated  by  the

filter  saturation  indication  system),  with  non-aggressive
detergents,  either  by  hand  or  in  the  dishwasher  at  low
temperatures  and  in  a  short  cycle.  When  cleaned  in  the
dishwasher,  the  metal  grease  filter  may  discolour,  but  its
filtering characteristics remain unchanged.

● 

Ceramic  activated  carbon  filter  maintenance

(For Recirculating Version only):
Traps  unpleasant  odours  generated  by  cooking.  The
product comes with a set of odour filters.

The  saturation  of  the  odour  filters  can  occur  after
somewhat prolonged use depending on the type of cooking
and  how  regularly  the  grease  filter  is  cleaned.  The  odour
filters can be thermally regenerated every 2/3 months in an
oven  pre-heated  to  200°C  for  45  minutes.  The  correct
regeneration of the filter ensures that it can constantly filter
efficiently for 5 years.

Please  note!

  Do  not  place  the  filters  on  the  floor  of  the

oven  but  rather  in  a  tray,  positioned  at  an  intermediate
height.

5. ASSISTANCE

TROUBLESHOOTING TABLE

Informative code

Description

Possible causes

Solution

The command zone switches off

due to an excessively high tem-

perature

The temperature inside the elec-

tronic parts is too high

Wait for the hob to cool be-

fore reusing it

Container unsuitable

Loss of magnetic properties

Remove the pot

Communication problems

between the user interface and

induction module

No power supply to the module;

the power cable has not been

connected correctly or it is faulty

Disconnect the hob from the
electrical network and check

the connection

For all other error sig-

nals

Call customer service and report the error code

CUSTOMER SERVICE

Before contacting Customer Service
1. Check that the problem cannot be solved by consulting the points in "Troubleshooting".
2. Switch the device off and on again to see if the problem resolves itself.

If the fault persists after the above checks, contact the nearest Customer Service centre.

22