Bertazzoni PRO90 6 MFE S XT - Инструкция по эксплуатации - Страница 9

9 

BEFORE LEAVING 

When the installation is complete, always check for gas leaks using a soapy solution. Never use a flame to 
make this check. Ignite all burners on high flame to ensure correct operation of gas valves, burners and 
ignition. Turn gas taps to low flame position and observe each burner to ensure they ignite completely at all 
ports and that the flame is stable. Conduct these checks for each burner individually and concurrently.  
 
Turn on each hob zone to check that all elements are functioning correctly. Remove all packaging and 
combustible items from the oven. Turn on the oven selector switch and thermostat knob to check that the 
oven is functional on all modes.  
 
When satisfied with the appliance, please instruct the user on the correct method of operation. In case the 
appliance fails to operate correctly after all checks have been carried out, please call the Bertazzoni Service 
Centre. 

Adaptation to different    

Before performing any maintenance operation, disconnect the appliance from                      

types of gas

                    the gas supply and electricity network. 

Replacing the gas nozzles to operate with another type of gas:  

Follow the instructions below to change the burner nozzles on the work 
surface: 

- 

Isolate the appliance from the electric outlet to avoid any type of electric contact. 

- 

Remove the grids from the work surface. 

- Remove 

the 

burners. 

- 

Unscrew the nozzles using a 7 mm spanner, and replace them (Fig.4) with those 

needed for the new type of gas 

accordingly

.

                                                                                              Fig 4 

Follow the instructions below to change the oven burner nozzle (model 90x60 
single oven): 

- 

Remove the oven level (Fig.5). 

- Loosen 

the 

screw 

V

 and pull out the burner from the support being careful not to 

damage the ignition plug and the thermocouple (Fig. 6). 

- Unscrew 

the 

nozzle 

R

 using a 10 mm spanner and replace it with the nozzle 

needed for the new type of gas accordingly. 

Fig 5                                                         Fig 6