Karcher HD 6/15 C 1.150-903 - Инструкция по эксплуатации - Страница 21

– 4

몇

WARNING

Risk of injury! Appliance, accessories, sup-
ply lines and connections must be in fault-
free condition. If they are not in a perfect 
state then the appliance must not be used.



DANGER

Danger of injury by electric shock.
The appliance may only be connected to al-
ternating current.
Minimum fuse strength of the socket (see 
Technical Data).
The highest allowed net impedance at the 
electrical connection point (refer to techni-
cal data) is not to be exceeded. In case of 
confusion regarding the power impedance 
present on your connection, please contact 
your utilities provider.
It is imperative to connect the appliance to 
the electric mains by means of a plug. It is 
forbidden to permanently connect the appli-
ance to the power supply. The plug serves 
for the disconnection from the mains.
Use the extension cord that has an ade-
quate cross-section (see "Technical Data") 
and unwind it fully from the cable drum.

For connection values, see type plate/tech-
nical data.

몇

WARNING

Observe regulations of water supplier.
 According to applicable regula-
tions, the appliance must never be 
used on the drinking water net 
without a system separator. A suit-
able system separator by KÄRCHER or al-
ternatively a system separator according to 
EN 12729 type BA must be used. 
Water that was flowing through a system 
separator is considered non-drinkable.

몇

CAUTION

Always connect the system separator to 
the water supply, never directly to the appli-
ance!

For connection values refer to technical 
specifications



Connect the supply hose (min. length 
7.5 m, minimum diameter 1/2“) to the 
water connection point of the machine 
and at the water supply point (for e.g. a 
tap).

Note:

The supply hose is not included.



Open the water supply.



Screw the suction hose with filter (order 
no. 4.440-238.0) to the water connection.



Deaerate the appliance:
Unscrew the nozzle. 
Switch on the appliance and let it run 
until the water exiting is bubble-free. 
At the end let the appliance run for ap-
prox. 10 seconds - then switch off. Re-
peat the procedure for a couple of times.



Switch off the appliance and fit the noz-
zle again. 



DANGER

Risk of explosion!
Do not spray flammable liquids.
If the appliance is used in hazardous areas 
(e.g. filling stations) the corresponding 
safety regulations must be observed.
Risk of injury! Hold the hand spray gun and 
the spray pipe firmly with both hands.
Risk of injury! The trigger and safety lever 
may not be locked during the operation.
Risk of injury! Contact Customer Service if 
the safety lever is damaged.
Risk of injury from high-pressure water jet. 
Slide the safety catch on the trigger gun for-
ward before performing any work with the 
appliance.

몇

CAUTION

Environmental damage. Clean motors at 
places with a corresponding oil separator 
only.

ATTENTION

Risk of blocking. Place the nozzles in the 
accessory compartment with their joint 
pointing upward.

Start up

Electrical connection

Water connection

Connection to the water supply

Drawing in water from open reservoirs

Operation

21

EN