TP-LINK EX220 AX1800 - Инструкция по эксплуатации - Страница 57

52

Chapter 6

Customize Your Network Settings

6  1  2   Use the Router as a DHCP Server

You can configure the router to act as a DHCP server to assign IP addresses to its clients. 
To use the DHCP server function of the router, you must configure all computers on the 
LAN to obtain an IP Address automatically.
Follow the steps below to configure DHCP server.

1  

Visit 

http://tplinkwifi.net

 or 

http://192.168.0.1

, and log in with the password you set 

for the router.

2  

Go to 

Advanced

>

Network

>

 LAN Settings

 page and select

IPv4

.

3  

Enable

DHCP

 function and select 

DHCP Server

.

4  

Specify the 

IP Address Pool

, the start address and end address must be on the 

same subnet with LAN IP. The router will assign addresses within this specified 
range to its clients. It is from 192.168.0.2 to 192.168.0.249 by default. 

5  

Enter a time duration in the

 Address Lease Time

 field. The 

Address Lease Time

 is 

the amount of time in which a DHCP client can lease its current dynamic IP address 
assigned by the router. After the dynamic IP address expires, the user will be 
automatically assigned a new dynamic IP address. 

6  

Keep the rest settings as the default settings and click 

Save

.

Note:

1.  The router can be configured to work as a 

DHCP Relay

. A DHCP relay is a computer that forwards DHCP data 

between computers that request IP addresses and the DHCP server that assigns the addresses. Each of the device’s 
interfaces can be configured as a DHCP relay. If it is enabled, the DHCP requests from local PCs will be forwarded to 
the DHCP server that runs on WAN side. 

2.  You can also appoint IP addresses within a specified range to devices of the same type by using 

Condition Pool

feature. For example, you can assign IP addresses within the range (192.168.0.50 to192.168.0.80) to Camera devices, 
thus facilitating the network management. Enable DHCP feature and configure the parameters according to your 
situation on the 

Advanced

 > 

Network

 >

 LAN Settings 

page.