Krups EA8050PE Compact Espresseria - Инструкция по эксплуатации - Страница 9

7

PREPARING STEAM

Steam froths up the milk to make a cappuccino or a caffe latte, for example, and also heats up liquids. As you need a higher
temperature to produce steam than to make an espresso, the appliance runs an additional pre-heating phase for steam.

While the screen displays the drink selection menu, press the “steam” key      . A screen
will inform you that the appliance is being pre-heated. Once the pre-heating phase has
been completed, a message will ask you to place a recipient under the steam nozzle.
Press the “steam” key      again to start generating steam. A little water will be produced
first and then steam will start. Use the same key to stop steam generation.

BE CAREFUL, BECAUSE THE CYCLE DOES NOT STOP IMMEDIATELY.

Check that the steam
nozzle is correctly fit-
ted.

Pour the milk into your
milk jug. Only half fill it.
Immerse the nozzle in the
milk.

aPress the “steam” key 

and follow the

instructions on the
screen.

Once your milk is frothy
enough…, 

again press the “steam”

key to stop the cycle.

Be careful, because the
cycle does not stop
immediately.

To remove any remaining
milk from the steam
nozzle, place a recipient
under the nozzle and
press the “steam” key        

Let the hot water escape
for at least 10 seconds
and then again press the
“steam” key      to stop
water.

To interrupt the steam function, just press any key.
If the nozzle is blocked, clean it out with a fine needle.
The maximum duration for production of steam per cycle is limited to 2 minutes.

You can remove the steam nozzle for thorough cleaning. Wash it
using a brush with water and a little non-abrasive washing up
liquid. Rinse and dry it. Before re-fitting, make certain that the air
inlet holes are not clogged by milk residues. Clean out the holes
with a needle if necessary.

FROTHING MILK

We recommend that you use pasteurised or UHT milk that has been recently opened. Untreated milk does not 
give the best results. After the steam function has been used, the nozzle can be hot, and we recommend that 
you wait for a few moments before handling it.

ENGLISH

SETTING UP THE AUTO-CAPPUCCINO XS 6000 (SOLD SEPARATELY)

To prevent milk from drying on the auto-cappuccino accessory, it must be cleaned thoroughly. It is recommend that you

wash it immediately by carrying out a cycle with steam and the accessory pot filled with water in order to clean the

inside of the nozzle. To do so, you can use liquid cleaner XS4000, available as an accessory.

Attach the various parts

together.

Select the cappuccino or caffe
latte position on the special nozzle.

Fill up the milk pot and place a
cup or a glass underneath the
auto-cappuccino nozzle.

Press the         button to start
and then to stop the cycle

Place your cup under the
coffee outlets and start a
coffee / espresso cycle.

This auto-cappuccino accessory makes it easier to make a cappuccino or a caffe latte.

XS 6000