Siemens TE502206RW - Инструкция по эксплуатации - Страница 22

18

de

en

N.B.:

 If the water filter is activated, the 

display will prompt you to remove the filter 

and then press the 

start

 button (10) again. 

Remove the filter now if you have not 

already done so�  

Press the 

start

 button (10).

Fill descaler

Press start

● Pour lukewarm water into the empty 

water tank (16) up to the 

0,5l

 mark and 

dissolve 2 Siemens descaling tablets in it� 

●

Press the 

start

 button (10).

Calc‘n‘Clean in progress

The descaling pro gramme will now run for 

about 10 minutes.

Pl ace container

Pull milk frother

●

Place a receptacle with a capacity of at 

least 1 litre under the outlet.

● Pull the milk frother (6) to open it.

Calc‘n‘Clean in progress

The descaling pro gramme will now run for 

about 12 minutes.

Clean / Fill water tank

Press start

● Rinse the water tank (16) and refill it with 

fresh water up to the 

max

 mark�

●

Press the 

start

 button (10).

Calc‘n‘Clean in progress

The descaling pro gramme now runs for 

about 30 seconds and rinses the appliance.

Push milk frother

● Push the milk frother (6) in to close it.

Calc‘n‘Clean in progress

The cleaning pro gramme will now run for 

about 8 minutes.

Empt y drip tray

Insert drip tray

● Empty drip tray (8) and replace them.

Replace the filter if one is being used. The 

appliance has finished cleaning is ready for 

use again.

Important:

 Wipe down the appliance using 

a soft, damp cloth to immediately remove 

any descaler residue. Such residue can 

cause corrosion. New sponge cloths may 

contain salts. Salts can cause rust film 

on stainless steel and must therefore be 

washed out thoroughly before use

Frost protection

¡

To avoid damage from low tempera-

tures during transport and storage, 

the appliance must be completely 

emptied first.

Note:

 The appliance must be ready for use 

and the water tank (16) filled.

1� 

Place a large receptacle under outlet.

2�  Press the 

h

 button (11).

The 

h

 button (11) flashes and the 

appliance now heats up for approx. 

20  seconds. The display then shows 

Pull milk frother

�

3� 

Open the milk frother (6) by pulling it out 

and release steam for about 15 seconds.

4�  Switch the appliance off at the power 

on/off switch 

O / I 

(9)�

5� 

Empty the water tank (16) and the drip 

tray (8)�