Электропилы STIGA SPR 500 AE 278420008/ST1 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
EN - 18
2.
When the safety button
is pressed, the blue light
does not switch on and the
“Attention” icon lights up
Low battery
Check the battery
status and recharge if
necessary (par. 7.2.2).
3.
By activating the safety
button when the throttle
lever and throttle lock lever
are pressed, the motor
does not start and the
"Attention" icon lights up
Incorrect starting procedure
Follow the instructions
(see chapter 6.4)
4.
The motor shuts down
whilst working
Battery is not inserted correctly
Make sure that the battery is
inserted correctly (par. 7.2.3)
Machine damaged
Do not use the machine
Remove the battery and
Contact a Service Centre.
5.
The motor stops whilst
working and the safety
button flashes
Low battery
Check the battery
status and recharge if
necessary (par. 7.2.2).
6.
With the throttle lock button
and throttle trigger lever on,
the chain does not turn
Excessive chain tensioning
Retension the chain (par. 6.1.3).
Bar and chain problems
Check that the chain runs
freely and the bar guides are
not deformed (par. 8.3, 8,4).
Machine damaged.
Do not use the machine.
Immediately turn off
the machine, remove
the battery and
Contact an Authorised
Service Centre.
7. The chain heats and
emits smoke on the
end part of the bar.
Excessive chain tensioning
Retension the chain (par. 6.1.3).
Lubricant oil tank empty.
Fill the lubricant oil
tank (par. 7.3).
8.
The motor runs irregularly
and lacks power when revved
Bar and chain problems
Check that the chain runs
freely and the bar guides
are not deformed.
9. No oil is released
Poor quality oil
When the motor is cold, empty
the tank, clean it and the
pipes with liquid detergent
and change the oil.
Lubrication holes are clogged
Clean them (chap. 7.6)
10.
The machine has
struck a foreign body.
Damaged or loose parts.
Stop the machine (
chap. 6.9
).
Inspect for damage.
Check for and tighten
any loose parts.
Have all checks, repair work
and replacements carried out
by an Authorised Centre only.
