Ryobi RCS2340 5133002186 - Инструкция по эксплуатации - Страница 6

4

| English

–

installing or removing attachments

–

FKHFNLQJPDLQWHQDQFHRUZRUNLQJRQWKHPDFKLQH

Ŷ

7KH VL]H RI WKH ZRUN DUHD GHSHQGV RQ WKH MRE EHLQJ
SHUIRUPHGDVZHOODVWKHVL]HRIWKHWUHHRUZRUNSLHFH
LQYROYHG )RU H[DPSOH IHOOLQJ D WUHH UHTXLUHV D ODUJHU
ZRUN DUHD WKDQ PDNLQJ RWKHU FXWV LH EXFNLQJ FXWV

etc. The operator needs to be aware and in control of 

HYHU\WKLQJKDSSHQLQJLQWKLVZRUNDUHD

Ŷ

Do not cut with your body in line with the guide bar 

DQG FKDLQ ,I \RX GR H[SHULHQFH NLFNEDFN WKLV ZLOO KHOS

prevent the chain coming into contact with your head 
or body.

Ŷ

'R QRW XVH D EDFN DQG IRUZDUG VDZLQJ PRWLRQ OHW WKH
FKDLQGRWKHZRUNNHHSWKHFKDLQVKDUSDQGGRQ¶WWU\WR

push the chain through the cut.

Ŷ

Do not put pressure on the saw at the end of the cut. 

%HUHDG\WRWDNHRQWKHZHLJKWRIWKHVDZDVLWFXWVIUHH

from the wood. Failure to do so could result in possible 
serious personal injury.

Ŷ

Do not stop the saw in the middle of a cutting operation. 
Keep the saw running until it is already removed from 
the cut. 

Push and pull

The reaction force is always opposite to the direction the 
chain is moving. Thus, the operator must be ready to 

FRQWUROWKHWHQGHQF\IRUWKHPDFKLQHWRSXOODZD\IRUZDUG
PRWLRQZKHQFXWWLQJRQWKHERWWRPHGJHRIWKHEDUDQGWKH
SXVKEDFNZDUGVWRZDUGVWKHRSHUDWRUZKHQFXWWLQJDORQJ

the top edge.

Saw jammed in the cut

6WRSWKHFKDLQVDZDQGPDNHLWVDIH'RQRWWU\WRIRUFHWKH
FKDLQ DQG EDU RXW RI WKH FXW DV WKLV LV OLNHO\ WR EUHDN WKH
FKDLQ ZKLFK PD\ VZLQJ EDFN DQG VWULNH WKH RSHUDWRU7KLV

situation normally occurs because the wood is incorrectly 
supported and forcing the cut to close under compression 
thereby pinching the blade. If adjusting the support does 
not release the bar and chain, use wooden wedges or a 
lever to open the cut and release the saw. Never try to start 

WKHFKDLQVDZZKHQWKHJXLGHEDULVDOUHDG\LQDFXWRUNHUI

Personal protective equipment

*RRG TXDOLW\ SHUVRQDO SURWHFWLYH HTXLSPHQW DV XVHG
E\ SURIHVVLRQDOV ZLOO KHOS WR UHGXFH WKH ULVN RI LQMXU\ WR

the operator. The following items should be used when 

RSHUDWLQJ\RXUFKDLQVDZ

Safety helmet

–

VKRXOGFRPSO\ZLWK(1DQGEH&(PDUNHG

Hearing protection

–

VKRXOGFRPSO\ZLWK(1DQGEH&(PDUNHG

Eye and face protection

–

VKRXOGEH&(PDUNHGDQGFRPSO\ZLWK(1IRU
VDIHW\JODVVHVRU(1IRUPHVKYLVRUV

Gloves

–

VKRXOGFRPSO\ZLWK(1DQGEH&(PDUNHG

Leg protection (chaps)

–

VKRXOG FRPSO\ ZLWK (1 EH &( PDUNHG DQG
SURYLGHDOOURXQGSURWHFWLRQ

Chainsaw safety boots

–

VKRXOG FRPSO\ ZLWK (1 ,62  DQG EH
PDUNHGZLWKDVKLHOGGHSLFWLQJDFKDLQVDZWRVKRZ
FRPSOLDQFH ZLWK (1  2FFDVLRQDO XVHUV
PD\ XVH VWHHO WRHFDS VDIHW\ ERRWV ZLWK SURWHFWLYH
JDLWHUV ZKLFK FRQIRUPWR(1  LIWKHJURXQG LV
HYHQDQGWKHUHLVOLWWOHULVNRIWULSSLQJRUFDWFKLQJRQ
XQGHUJURZWK

Chainsaw jackets for upper body protection

–

VKRXOGFRPSO\ZLWK(1DQGEH&(PDUNHG

INSTRUCTIONS CONCERNING THE PROPER TECH-
NIQUES FOR BASIC FELLING, LIMBING, AND CROSS-
CUTTING

Understanding the forces within the wood

When you understand the directional pressures and 
stresses inside the wood you can reduce the “pinches” or 
at least expect them during your cutting. Tension in the 

ZRRG PHDQV WKH ¿EHUV DUH EHLQJ SXOOHG DSDUW DQG LI \RX
FXWLQWKLVDUHDWKH³NHUI´RUFXWZLOOWHQGWRRSHQDVWKHVDZ

goes through. If a log is being supported on a saw horse 
and the end is hanging unsupported over the end then 
tension is created on the upper surface due to the weight 

RI WKH RYHUKDQJLQJ ORJ VWUHWFKLQJ WKH ¿EHUV /LNHZLVH WKH
XQGHUVLGH RI WKH ORJ ZLOO EH LQ FRPSUHVVLRQ DQG WKH ¿EHUV

are being pushed together. If a cut is made in this area the 

NHUIZLOOKDYHWKHWHQGHQF\WRFORVHXSGXULQJWKHFXW7KLV

would pinch the blade.

Felling a tree

See page 239 - 240.

:KHQ EXFNLQJ DQG IHOOLQJ RSHUDWLRQV DUH EHLQJ SHUIRUPHG

by two or more persons at the same time, the felling 

RSHUDWLRQVVKRXOGEHVHSDUDWHGIURPWKHEXFNLQJRSHUDWLRQ

by a distance of at least twice the height of the tree being 
felled. Trees should not be felled in a manner that would 

HQGDQJHU DQ\ SHUVRQ VWULNH DQ\ XWLOLW\ OLQH RU FDXVH DQ\
SURSHUW\ GDPDJH ,I WKH WUHH GRHV PDNH FRQWDFW ZLWK DQ\
XWLOLW\OLQHWKHFRPSDQ\VKRXOGEHQRWL¿HGLPPHGLDWHO\
7KH FKDLQVDZ RSHUDWRU VKRXOG NHHS RQ WKH XSKLOO VLGH RI
WKHWHUUDLQDVWKHWUHHLVOLNHO\WRUROORUVOLGHGRZQKLOODIWHU

it is felled.
An escape path should be planned and cleared as 
necessary before cuts are started. The escape path should 

H[WHQGEDFNDQGGLDJRQDOO\WRWKHUHDURIWKHH[SHFWHGOLQH

of fall.
Before felling is started, consider the natural lean of the 
tree, the location of larger branches and the wind direction 
to judge which way the tree will fall.

5HPRYH GLUW VWRQHV ORRVH EDUN QDLOV VWDSOHV DQG ZLUH

from the tree.
Do not attempt to fell trees which are rotten or have been 

GDPDJHG E\ ZLQG ¿UH OLJKWQLQJ HWF 7KLV LV H[WUHPHO\

dangerous and should only be completed by professional 
tree surgeons.

Ŷ

Notching undercut

See page 239 - 240.

0DNH WKH QRWFK  WKH GLDPHWHU RI WKH WUHH
SHUSHQGLFXODU WR WKH GLUHFWLRQ RI IDOOV 0DNH WKH ORZHU

horizontal notching cut first. This will help to avoid 
pinching either the saw chain or the guide bar when the