Makita DUC356Z - Инструкция по эксплуатации - Страница 18

18 ENGLISH

TROUBLESHOOTING

Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual, 

do not attempt to dismantle the tool. Instead, ask Makita Authorized Service Centers, always using Makita replace-

ment parts for repairs.

Malfunction status

Cause

Action

The chain saw does not start.

Battery cartridge is not installed.

Install a charged battery cartridge.

Battery problem (low voltage).

Recharge the battery cartridges. If recharg-

ing is not effective, replace the battery 

cartridge.

Main power switch is off.

The chain saw is automatically turned off if 

it is un-operated for a certain period. Turn 

on the main power switch again.

The saw chain does not run.

Chain brake activated.

Release chain brake.

The motor stops running after a little use.

Battery's charge level is low.

Recharge the battery cartridges. If recharging is 

not effective, replace the battery cartridge.

No oil on the chain.

Oil tank is empty.

Fill the oil tank.

Oil guide groove is dirty.

Clean the groove.

Poor oil delivery.

Adjust the amount of oil delivery with the 

adjusting screw.

The chain saw does not reach maximum 

RPM.

Battery cartridge is installed improperly.

Install the battery cartridges as described 

in this manual.

Battery power is dropping.

Recharge the battery cartridge. If recharg-

ing is not effective, replace the battery 

cartridge.

The drive system does not work correctly.

Ask the authorized service center in your 

region for repair.

The main power lamp is blinking in green.

Switch trigger is pulled under an unoperat-

able condition.

Pull the switch trigger after the main power 

switch is turned on and the chain brake is 

released.

Chain does not stop even the chain brake 

is activated:  

Stop the machine immediately!

The brake band is worn down.

Ask the authorized service center in your 

region for repair.

Abnormal vibration:  

Stop the machine immediately!

Loose guide bar or saw chain.

Adjust the guide bar and saw chain 

tension.

Tool malfunction.

Ask the authorized service center in your 

region for repair.

The Torque Boost mode is not available 

after replacing the battery cartridge with a 

fully charged one.

Depending on the usage conditions, the 

Torque Boost mode is not available after 

replacing the battery cartridge.

Use the tool in the normal mode until the 

installed battery cartridge becomes empty, and 

then replace the battery cartridge with a fully 

charged one, or recharge the battery cartridge.

The saw chain cannot be installed.

The combination of saw chain and 

sprocket is not correct.

Use the correct combination of saw chain 

and sprocket by referring to the section for 

specifications.

OPTIONAL 

ACCESSORIES

CAUTION:

These accessories or attachments are 

recommended for use with your Makita tool specified in 

this manual.

 The use of any other accessories or attach-

ments might present a risk of injury to persons. Only use 

accessory or attachment for its stated purpose.

If you need any assistance for more details regarding these 

accessories, ask your local Makita Service Center.

• 

Saw chain

• 

Guide bar

• 

Guide bar cover

• 

Sprocket

• 

File

• 

Makita genuine battery and charger

WARNING:

If you purchase a guide bar of 

different length from the standard guide bar, also 

purchase a suitable guide bar cover together. It 

must fit and fully cover the guide bar on the chain 

saw.

NOTE:

 Some items in the list may be included in the 

tool package as standard accessories. They may 

differ from country to country.