FALMEC INDUCTION HOB INOX (880) - Инструкция по эксплуатации - Страница 19

19

ENGLISH

AUTOMATIC SHUTDOWN

For the automatic shutdown function:

1 - turn on the cooker;

2 - select the cooking area;

3 - select the level;

4 - set the timer as described above.

To set the automatic shutdown for another cooking area, repeat the procedure from 

point 2.

TIMER and AUTOMATIC SHUTDOWN can be used simultaneously.

ADDITIONAL FUNCTIONS

"90 PLUS" MODEL

STOP AND GO

This function allows to temporarily stop cooking and restore it with the same settings.
to enable touch the key  .

If the function is not deactivated within 10 minutes, the cooker switches off.

For deactivation

Touch the key    and within 5 seconds completely slide the slider to right.

AUTOMATIC PROGRAMMING OF THE COOKING

This function allows to speed up the start of cooking.

The procedure is the following:

1 - turn on the cooker

2 - touch for more than 2 seconds the desired level of cooking: 

on the display   will be displayed and the desired level of cooking 

.

For a certain period the cooking area will work at the maximum power to then rech the 

set level.

To deactivate the function:

touch again the control 

 and change the power level.

RESET FUNCTION for accidental switch off

After turning off the cooker, it is possible to restore the last selected settings:

· Status of cooking of all cooking areas (power).

· Minutes and seconds of the timer by programmed cooking areas.

· Automatic programming of cooking.

The restore procedure is the following:

- turn on the cooker.
· touch within 6 seconds the key  .

Previous settings are restored.

CHEF FUNCTION

It allows setting for each cooking area pre-defined power for each cooking phase.

Area 4:

 power level 9. Cooking start.

Area 3:

 power level 6. Cooking continuation.

Area 2:

 power level 3. Cooking end.

Area 1:

 power level 1. Keep warm.

TOUCH PUSHBUTTON PANEL

(For use with remote hoods)

ON/OFF

Motor on/off and Speed 1 

Speed 2 activation

Speed 3 activation

Speed 4 is only active for a few minutes, then speed 3 activates.

Light on/off

Short pulse: 

light on/off

Long pulse: 

change of light tone from 2700K-5600K (hoods with dynamic 

light ( 

)

TIMER

 (red LED flashing)

Auto switch-off after 15 min.

CODE CHANGE ON HOOD CONTROLS

In case of only one hood control, go to item 2.
In case of several control positions in the same room, a new code can be created by 
following the procedure below.

Disconnect the power to the hood before starting the procedure.

1) - CREATE A NEW CODE

The procedure is to be carried out 

using the pushbutton panel found on the hob.

•

  Press LIGHT 

 and TIMER 

 simultaneously until the display starts flashing.

•

  Press the 2nd speed 

 key for a few seconds.

Reconnect the hood to the electrical power supply, making sure that the 

lights and motor are off. 

2) -

ASSOCIATION BETWEEN THE HOB CONTROLS AND THE HOOD

press LIGHT 

 or TIMER 

 (see the instruction manual for the hood) 

on the hood 

pushbutton panel

 for 2 seconds:

the key flashes.

press the LIGHT 

 key on the hob within 5 seconds.

RESTORING DEFAULT CODE

the procedure is to be carried out if the hob is disposed of, sold or transferred.

Disconnect the power to the hood before starting the procedure.

•

  Press LIGHT 

 and TIMER 

 at the same time until the keys start flashing.

•

  Press the 

 and 

 speed keys for a few seconds.

•

  Perform the procedure described in point 2.