KitchenAid KHCMF 45000 - Инструкция по эксплуатации - Страница 27

GB

27

Installation

!

 Before operating your new appliance please read 

this instruction booklet carefully. It contains important 

information for safe use, installation and care of the 

appliance.

!

 Please keep these operating instructions for future 

reference. Pass them on to possible new owners of the 

appliance.

Positioning

!

 Keep packaging material out of the reach of children. 

It can become a choking or suffocation hazard (see 

Precautions and tips).

!

 The appliance must be installed by a qualified professional 

according to the instructions provided. Incorrect installation 

may cause harm to people and animals or may damage 

property.

Built-in appliance

Use an appropriate cabinet to ensure that the appliance 

operates properly.

•  the supporting surface must be heat-resistant up to a 

temperature of approximately 100°C.

•  avoid installing the hob above a dishwasher: if this 

cannot be avoided, place a waterproof separation 

device between the two appliances.

•  depending on the hob you want to install (see figure), 

the cabinet must have the following dimensions:

460

510

495

445

241

261

Installing semi-flush hobs (KHCMS 45000)

All the necessary precautions must be taken in order to 

install the appliance in conformity with current accident-

prevention regulations (CEI-UNI-CIG) relating to gas and 

electrical connections. To ensure sit-on hobs installed in 

kitchen cabinets operate correctly, the minimum distances 

indicated  should  be  observed  (see  figure). All  adjacent 

surfaces and the back panel should also be able to 

withstand an overheating temperature of 65°C.

50 min

700 min

50 min

Securing the appliance to the cabinet

The appliance must be installed on a perfectly level 

supporting surface.

Any deformities caused by improper fixing could affect the 

features and operation of the hob.

•  Before fitting the hob to the worktop, position the seal 

provided along the perimeter of the hob, as illustrated 

in the figure.

•  The installation cavity should have the dimensions 

indicated  in  the  figure  accompanying  the  previous 

paragraph.

Fix the hob as follows:

1. Use the screws supplied to fit the 4 alignment springs 

in the holes provided at the central point of each side of 

the part underneath the hob.

2. Place the hob in the cavity, make sure it is in a central 

position and push down on the whole perimeter until the