Makita VC004GLZ01 - Инструкция по эксплуатации - Страница 19

19 ENGLISH

5.

  Push the wireless activation button on the tool 

briefly. The wireless activation lamp will blink in blue.

► 

Fig.35:

1.

 Wireless activation button 

2.

 Wireless 

activation lamp

6.

  Pull the switch trigger of the tool. Check if the 

cleaner runs while the switch trigger on the tool is being 

pulled.

CAUTION:

Always check if the wireless acti-

vation function works before starting a work with 

the tool. 

To stop the wireless activation, push the wireless activa

-

tion button on the tool, or set the stand-by switch on the 

cleaner to "I" or "O".

NOTE:

 The wireless activation lamp on the tool will 

stop blinking in blue when there is no operation for 

2 hours. In this case, set the stand-by switch on the 

cleaner to "AUTO" and press the wireless activation 

button on the tool again.

NOTE:

 The cleaner starts/stops with a delay. There is 

a time lag when the cleaner detects a switch opera

-

tion of the tool.

NOTE:

 The transmission distance of the wireless unit 

may vary depending on the location and surrounding 

circumstances.

NOTE:

 When two or more tools are registered to one 

cleaner, the cleaner may start running even if you 

don't pull the switch trigger because other user is 

using the wireless activation function.

Cancelling tool registration for the 

cleaner

Perform the following procedure when cancelling the 

tool registration for the cleaner.

1.

  Install the wireless units to the cleaner and the 

tool, respectively.

2.

  Install the batteries to the cleaner and the tool.

3.

  Set the stand-by switch on the cleaner to "AUTO".

► 

Fig.36:

1.

 Stand-by switch

4.

  Press the wireless activation button on the cleaner 

for 6 seconds. The wireless activation lamp blinks in 

green and then become red. After that, press the wire

-

less activation button on the tool in the same way.

► 

Fig.37:

1.

 Wireless activation button 

2.

 Wireless 

activation lamp

If the cancellation is performed successfully, the wire

-

less activation lamps will light up in red for 2 seconds 

and start blinking in blue.

NOTE:

 The wireless activation lamps finish blinking in 

red after 20 seconds elapsed. Press the wireless acti-

vation button on the tool while the wireless activation 

lamp on the cleaner is blinking. If the wireless acti

-

vation lamp does not blink in red, push the wireless 

activation button briefly and hold it down again.

Erasing all tool registrations

You can erase all tool registrations from the cleaner as 

follows.

► 

Fig.38:

1.

 Stand-by switch 

2.

 Wireless activation 

button 

3.

 Wireless activation lamp

1.

  Install the wireless unit to the cleaner.

2.

  Install the batteries to the cleaner.

3.

  Set the stand-by switch to "AUTO".

4.

  Hold down the wireless activation button for about 

6 seconds until the wireless activation lamp blinks in red 

(about twice per one second).

5.

  When the wireless activation lamp starts blinking 

in red, release your finger from the wireless activation 

button. Thereafter, hold down the wireless activation 

button again for about 6 seconds.

6.

  When the wireless activation lamp starts blinking 

fast (about 5 times per one second) in red, release your 

finger from the wireless activation button. When the 

wireless activation lamp lights up in red and later lights 

off, all tool registrations are erased.

NOTE:

 If the wireless activation lamp does not blink 

in red, press the wireless activation button briefly and 

try again.