Ryobi ONE+ LLCDI18022LX - Инструкция по эксплуатации - Страница 9

4

English

OPERATION

TORQUE ADJUSTMENT

When using the drill-driver for various driving applications, 

it becomes

o i

 t ncrease or decrease the torque 

in order to help pre

screw heads , threads , w orkpiece, etc.

intensity should correspond to the scre

torque is too high or the scre

 In gener

a

l, torque 

 necessar

y

vent the possibility of damaging

w diameter. If the 

may be damaged or broken.
The torque is adjusted by rotating the torque adjustment ring.
The torque is

is set on a higher setting.   The torque is less when the  

torque adjustment ring is set on a lower setting.
The proper setting depends on the type of mater

i

al 

 g

r

eater when the torque adjustment r

i

ng 

ws too small, the scre

w

s 

the size of screw you are using.

BIT STORAGE

When not in use, bits provided with the drill can be placed 

in the storage areas located on the base of the drill.

and 

WARNING

:

Make sure to

chuck

 Do not inser

t

ja

w

s.

 inser

t

 the dr

il

l bit straight into the 

chuck

at an angle then tighten.   This could 

cause the dr

 ja

w

s 

ill bit to be

from the drill, 

 thro

w

n 

resulting in possible

or  

injur

y

 ser

i

ous

personal

damage to the chuck.

NOTE:

 Rotate the chuc

arrow 

LOCK

 to tighten the chuc

mar

k

ed 

k body in the direction of the

the dr

i

ll bit into the  

use a wrench to tighten or loosen the chuck jaws.

REMOVING BITS

■

Lock the switch trigger by placing the rotation selector 

in the center position.

■

Open the chuck jaws.

NOTE:

 Rotate the chuc

arrow marked 

UNLOCK

 to loosen the chuc k jaws. Do 

not use a wrench to tighten or loosen the chuck jaws.

■

Remove the drill bit.

DRILLING

■

Check the rotation selector f

k body in the direction of the 

k

 Do not  

 ja

w

s.

(forward or reverse).

■

Secure the

to be dr

clamps to keep it from turning as the drill bit rotates.

■

Hold the drill firmly and place the bit at the point to be 

drilled.

See Figure 8.

 mater

i

al

illed in a vise or with  

or the correct setting  

INSTALLING BITS

■

Lock the switch trigger by placing the rotation selector 

in the center position.

■

Open or close the chuc

opening is slightly larger than the bit si

ze

k

to a point where the  

 ja

w

s 

to use. Also, raise the front of the dr

i

ll

s

lightly to k

e

ep 

the bit from falling out of the chuck jaws.

■

Insert the drill bit.

■

Tighten the chuck jaws on the drill bit.

See Figure 8.

y ou intend 

See Figure 2.

See Figure 7.

EN

FR

IT

NL

PT

DA

SV

FI

NO

RU

PL

CS

HU

RO

LV

LT

ET

HR

SL

SK

EL

TR

DE

ES