MONSHER MD 4502 - Инструкция по эксплуатации - Страница 81

Русский

81

English

Water Softener

The water softener must be set manually, using the water hardness dial.

The water softener is designed to remove minerals and salts from the water, 

which would have a detrimental or adverse effect on the operation of the appliance. 

The more minerals there are, the harder your water is.

The softener should be adjusted according to the hardness of the water in your 

area. Your local Water Authority can advise you on the hardness of the water in your 

area.

Adjusting salt consumption 

The dishwasher is designed to allow for adjustment in the amount of salt 

consumed based on the hardness of the water used. This is intended to optimise 

and customise the level o f salt consumption.  

Please follow the steps below for adjustment in salt consumption.

1.  Switch on the appliance;

2.  Press the Program button for more than 5 seconds to start the water 

softener set model within 60seconds after the appliance was switched on;

3.  Press the Program button to select the proper set according to 

your local environment, the sets will change in the following sequence: 

H1->H2->H3->H4->H5->H6;

4.  Press the On/Off button to end the set up model.

WATER HARDNESS

Water 

softener level

Salt consumption

(gram/cycle)

German

dH

French 

fH

British

Clarke

Mmol/l

0–5

0–9

0–6

0–0,94

H1

0

6–11

10–20

7–14

1,0–2,0

H2

9

12–17

21–30

15–21

2,1–3,0

H3

12

18–22

31–40

22–28

3,1–4,0

H4

20

23–34

41–60

29–42

4,1–6,0

H5

30

35–55

61–98

43–69

6,1–9,8

H6

60

1°dH=1.25 °Clarke=1.78 °fH=0.178mmol/l

The manufactory setting: H3 

Contact your local water board for information on the hardness of your water 

supply.