MONSHER MD 4502 - Инструкция по эксплуатации - Страница 64

Русский

64

English

About the safety supply hose

The safety supply hose consists of the double walls. The hose’s system guarantees 

its intervention by blocking the flow of water in case of the supply hose breaking 

and when the air space between the supply hose itself and the outer corrugated 

hose is full of water.

 WARNING

A hose that attaches to a sink spray can burst if it is installed on the same water 

line as the dishwasher. If your sink has one, it is recommended that the hose be 

disconnected and the hole plugged. 

WATER SUPPLY AND DRAIN

Cold water connection

Connect the cold water supply hose 

to a threaded 3/4 (inch) connector and 

make sure that it is fastened tightly in 

place.

If the water pipes are new or have 

not been used for an extended period 

of time, let the water run to make sure 

that the water is clear. This precaution is 

needed to avoid the risk of the water inlet 

to be blocked and damage the appliance.

safety supply hose

ordinary supply hose

How to connect the safety supply hose

1.  Pull The safety supply hoses completely out from storage compartment 

located at rear of dishwasher.

2.  Tighter the screws of the safety supply hose to the faucet with thread 3/4 inch.

3.  Turn water fully on before starting the dishwasher.

How to disconnect the safety supply hose

1.  Turn off the water.

2.  Unscrew the safety supply hose  from the faucet.