BRAYER BR1105 - Инструкция по эксплуатации - Страница 13

13

EN

will light up, and the illumination of buttons (18, 

19, 20) will be flashing. When the buttons (18, 19, 

20) illumination will glow constantly, it means that 

preheating is finished.

9.  Press the button (20) «

», depending on the 

preset water supply time, press the button (20) «

» once or twice, fill a cup of approximately 100 

ml capacity with water (it is necessary to remove 

water from the boiler and fill it with citric acid 

solution), if necessary, switch the water supply off 

by pressing the button (20) «

» again. Pour the 

liquid out from the cup.

10.  Switch the water supply on by pressing the button 

(20) «

» and fill a cup of about 100 ml capacity, 

press the button (20) «

» again to switch the 

water supply off and pour the liquid out of the cup.

11. 

After a while repeat the procedure described in 

the paragraph 10 and fill the cup of about 100 ml 

capacity again.

12.  Press the steam supply button (19) « ». Put a 

suitable bowl under the tip (12) and slightly open 

the steam supply by turning the knob (9) « 

 » 

counterclockwise. Carefully turn the knob (9) « 

 » to the maximal steam release position, 

release the steam for about 1 minute, then close 

the steam by turning the knob (9) « 

 » 

clockwise until bumping «•». 

13. 

Switch the coffee maker off by pressing the on/off 

button (17) «

»,. Wait for 10-15 minutes.

Note:

 some water or steam may appear from the filter 

holder (5), it is normal.

REMOVING MINERAL SCALE

For effective operation of the coffee maker we 

recommend removing scale every 2-3 months and when 

using “hard” water more often.

1.  Make sure that the power plug is not inserted into 

the mains socket.

2.  Make sure that the steam supply is closed. To 

do this turn the knob (9) « 

 » clockwise until 

bumping «•».

3. 

Make citric acid solution: 2 teaspoons of acid to 1 

litre of water and pour the solution into the water 

tank (15). Install the tank (15) back to its place.

4. 

Install the coffee filter (6) into the holder (5) having 

preliminary matched the ledge on the filter (6) with 

the groove on the holder (5) and turn the filter (6) 

counter/clockwise to fix the filter. Do not put ground 

coffee into the filter (6).

5. 

Install the filter holder (5) into the coffee maker. The 

holder (5) ledges should match the grooves on the 

boiler «INSERT», after that turn the filter holder 

handle (4) to the right until bumping «LOCK».

6.  Place a suitable cup on the grid (2).

7.  Insert the power plug into the mains socket.

8.  Switch the espresso machine on by pressing the 

on/off button (17) «

», the button (17) illumination