Krups EA894T10 Evidence Plus - Инструкция по эксплуатации - Страница 40

DRINKS

After starting to make a drink, if you ask for 
an extra shot the machine tells you that this 
is not possible.

The coffee grounds collector is full and the extra shot function 
is not available.
Once the drink has been made, you have the option to restart an 
espresso after you have emptied the coffee grounds collector.

The One Touch Cappuccino block does not 
suck the milk up.
The One Touch Cappuccino block makes 
little or no froth.

Verify that the block is assembled correctly (including the 
connector in the milk tube) 

Fig. 35

Check that the connector 

Fig. 29

 is not blocked or dirty; soak it 

in a mixture of warm water and dishwasher liquid, then rinse and 
dry before reassembly.
Ensure that the steam output is not blocked. If it is, see “The 
steam output of your machine appears to be partially or 
completely blocked”.
Verify that the flexible pipe is not blocked or kinked and that it is 
well seated in the One Touch Cappuccino block to avoid any air 
leaks. Check that it is properly immersed in the milk.
Rinse and clean the block (see chapters corresponding to the 
rinsing and cleaning of the One Touch Cappuccino block).
For the milk-based preparations, we advise you to use 
fresh, pasteurised or UHT milk, recently opened. It is also 
recommended to use a cold container.

The milk or the water is not flowing 
correctly in the cup or cups.

Check that the One Touch Cappuccino block is correctly 
positioned.

The coffee is flowing too slowly.

Turn the “fineness of grinding” button to the right 

(I)

 to obtain a 

coarser ground coffee (depending on the type of coffee used).
Perform one or several rinsing cycles.
Start the cleaning of the machine (see “Automatic cleaning 
program”)
Change the Claris Aqua Filter System cartridge (see “Installing 
the filter”)

Traces of milk are present in an americano 
or a hot water.

Perform a milk rinsing, or disassemble and clean the One Touch 
Cappuccino block before starting to prepare the drink.

The coffee is too light or not full-bodied 
enough.

Avoid the use of oily, caramelised or flavoured coffees. 
Check that the bean container contains coffee and that it is 
moving down correctly.
Decrease the volume of the preparation and increase the 
strength of the preparation using the DARK function.
Turn the “fineness of grinding” button to the left to obtain a finer 
ground coffee.
Make your drink in two cycles using the 2-cup function.

The espresso or the coffee is not hot 
enough.

Perform a coffee rinsing circuit before you start to make your 
coffee.
Increase the temperature of the coffee in the Settings menu.
Heat the cup in the rinsing with hot water before starting to 
prepare the drink.

Your tea is not hot enough or is too hot.

Increase or decrease the temperature of the hot water in the 
Settings menu.

  If one of the problems outlined in the table persists, contact the KRUPS Consumer Service.

38