Krups EA894T10 Evidence Plus - Инструкция по эксплуатации - Страница 37

35

Cleaning program for the “One Touch Cappuccino” block 

(approximately 5 minutes) 

Cleaning the “One Touch Cappuccino’ block allows you to fight against milk deposits and ensures the best possible 
hygiene.

To perform this cleaning you will need:

- KRUPS cleaning liquid
- 1 container (minimum 600 ml)
-  Press the Settings button

.

-  Select Maintenance.
-  Then Milk Cleaning.
-  Let yourself be guided by the instructions on the screen.

Removing the “One Touch Cappuccino” block

In addition to the rinsing it is necessary to clean the different elements of the block after each use. To remove the block 
follow the following instructions:

-  Remove the milk tube 

Fig. 21

-  Remove the front cover of the “One Touch Cappuccino” removable block by sliding it down and pulling it 

toward you. 

Fig. 22

-  Remove the “One Touch Cappuccino” block by pulling on the upper part of the block and pull the orange 

cleaning tool. 

Fig. 23

- Completely dismantle the block. 

Fig. 24

- Remove the connector of the milk tube. 

Fig. 27

-  Clean all of the dismantled parts (block, connector and milk tube) in soapy water. Then rinse them under hot 

water. 

Fig. 28

- Once the elements are cleaned and dried, assemble the block. Put it back in its original position. 

Fig. 32

- Reposition the front cover of the removable “One Touch Cappuccino” block. 
- Replace the connector in the milk tube. 

Fig. 35

- Reconnect the milk tube to the “One Touch Cappuccino” removable block”. 

Fig. 36

Automatic descaling program of the steam circuit: 

(approximately 20 minutes)

Descaling your machine ensures its proper functioning and eliminates any deposit of limescale or tartar that can influence 
the taste of the coffee.
The frequency at which this program is run depends on the quality of the water used and whether a Claris Aqua Filter 
System filter cartridge is used or not. The more limescale from your water, the more often the descaling has to be carried 
out.

Warning:

  If your appliance is equipped with our Claris cartridge Aqua Filter System cartridge please remove it 

before the descaling procedure.

To perform this cleaning you will need:

- 1 dose of KRUPS descaler
-  1 container of a minimum of 600 ml

The cycle will link two phases:

- 1 descaling phase
- 1

st

 rinsing phase

- 2

nd

 rinsing phase

When do I run this program? 

When you need to carry out descaling, your appliance will notify you. 

-  Fill the water tank up to the 

CALC

 mark.

-  Pour the dose of descaler into the water tank.
-   Press 

 to start the descaling program. 

-  To postpone it press 

. 

-  Then let yourself be guided by the instructions on the screen.

!

Important:

  You do not have to run the cleaning program as soon as the appliance requests it, but you must do it 

reasonably soon after. If the cleaning is postponed the alert message will remain displayed as long as 
the operation has not been performed.

EN