Siemens TE501203RW - Инструкция по эксплуатации - Страница 9

9

en

“Coffee strength” rotary knob

This rotary knob (13) is used 

to adjust the coffee strength 

or select the setting for pre-

ground coffee.

h

to

g

G

Very mild

Mild

Medium

Strong 

Ground coffee

“Drink selection” rotary knob

This rotary knob (14) is 

used to select the required 

beverage and quantity. It is 

also used to change user 

settings.

a

to 

c

Small espresso

Espresso

Small café crème

Café crème

Large café crème

b

to

d

2 small espresso

2 espresso

2 small café crèmes

2 café crèmes

2 large café crèmes

Milk frother

Pull the milk frother (6a) out to open it and 

push it back in to close it.

Before using for  

the first time

General

Fill the water tank with fresh, uncarbonated 

water only and preferably use only beans 

or coffee blends suitable for fully automatic 

espresso and coffee machines. Do not 

use coffee beans that have been glazed, 

caramelised or treated with other additives 

containing sugar, since they will block the 

brewing unit. 

The water hardness setting can be adjusted 

on this appliance. The factory setting for the 

water hardness is 4. Check the hardness 

of the water you use with the enclosed test 

strip. If the test reveals a value other than 4, 

change the setting on the appliance ac-

cordingly after switching on (see “Settings”, 

“Water hardness” on page 11).

Setting up the appliance

1.  Remove the protective film.

2.  Place the fully automatic espresso ma-

chine on a flat, water-resistant surface 

that can take its weight. The ventila-

tion slots on the appliance must not be 

covered.

Important:

 Only use the appliance in 

frost-free rooms. If the appliance has been 

transported or stored at temperatures below 

0 °C, wait at least 3 hours before operation.

3.  Pull out the mains plug from the cable 

compartment (20) and plug it in. Adjust 

the length of the cable by pushing it 

back in and pulling it out. To do this, 

place the appliance with its back flush 

with the edge of the work surface and 

either pull the cable 

downwards

 or 

push it 

upwards

.