Siemens TE501203RW - Инструкция по эксплуатации - Страница 11

11

en

9.  Pull out the milk frother (6) to open it. 

LED 

F

 flashes.

10. Water will now flow through the filter and 

rinse it.

11. When LED 

F

 lights up constantly, 

press in the milk frother (6) to close it.

12. Empty the container. 

The appliance is ready to use again.

Information:

 Rinsing the filter simultane-

ously activates the setting for the change 

filter display (= LED 

D

 flashes).

The filter is no longer effective when the 

change filter display appears, or at the 

latest after two months. It needs to be re-

placed for reasons of hygiene and so that 

there is no build-up of limescale (this could 

damage the appliance). Replacement filters 

can be obtained from retailers (TZ70003) or 

from customer service (467873). If no new 

filter is inserted, change the setting for the 

filter (see "Water hardness”).

Information:

 You can use the filter indicator 

to mark the month in which you inserted the 

filter. You can also mark the month in which 

you will need to replace the filter next (at 

the latest after two months).

Information:

 If the appliance has not been 

used for a prolonged period (for example, 

when you are on vacation), the existing filter 

should be rinsed before the appliance is 

used again. To do so, dispense a cup of hot 

water and pour it away.

Settings

You can customize the settings on the 

appliance.

You can make the following adjustments:

Water hardness

The water hardness setting can be adjusted 

on this appliance. It is important to set the 

water hardness correctly so that the ap-

pliance can accurately indicate when it is 

time to run the descale process. The factory 

setting for the water hardness is 4. You can 

establish the water hardness either by us-

ing the test strip provided or by asking your 

local water provider.

Dip the test strip in the water briefly, shake it 

gently and check the result after one minute.

Level

Water hardness

German (°dH)

French (°fH)

1

2

3

4

1-7

8-14

15-21

22-30

1-13

14-25

26-38

39-54

If you wish to change the default degree of 

water hardness, or if you have inserted a 

water filter, proceed as follows:

1.  Turn the rotary  

knob (13) to position 

2.  Press and hold buttons 

B

 (11) and 

A

(12) simultaneously for at least 5  seconds. 

The set water hardness is indicated by the 

number of LEDs that now light up.

3.  Now press the start button (10) repeat-

edly until the required water hardness 

is indicated, e. g., for water hardness 3, 

LEDs 

D

, 

E

 and 

F

 will light up.