Ryobi RLM46175YL 5133003673 - Инструкция по эксплуатации - Страница 14

English

12

TROUBLESHOOTING

Problem

Possible cause

Solution

The handle is not in 
the correct position.

The handle is positioned incorrectly.

Check and ensure that the lower part of handle is pushed 
fully back and snapped into proper position.

The handle knobs are not tightened.

Tighten the handle knobs.

.

T h e   m o w e r   d o e s 
not start.

There is no petrol.

Fill the mower with petrol. If the mower still does not start, 
contact an authorised service centre.

.

7KHHQJLQHLVÀRRGHG

Wait for 15 minutes, then try starting the mower again. Do 
not prime before attempting to start.

The starter rope is harder to pull now 
than when it was new.

Contact an authorised service centre.

The mower is hard 
to push.

The grass to be mowed is too tall.

The mower housing and blade is being 
dragged through heavy grass.

The cutting height is too low.

Raise the cutting height.

The wheel assembly needs cleaning

.

C l e a n   t h e   w h e e l   a s s e m b l y.   S e e   t h e  

D r i v e   G e a r 

Maintenance

 section.

T h e   m o w e r   i s 
vibrating at a higher 
speed.

The blade is unbalanced.

Replace the blade.

The motor shaft is bent.

Stop the product. Make sure that all moving parts have 
come to a complete stop. Allow the product to cool down. 
Disconnect the spark plug wire. Inspect for damage. Have 
the damage repaired by an authorised service centre 
before restarting the product.

The grass catcher 
is not being filled 
up with grass even 
t h o u g h   g r a s s   i s 
being cut from the 
lawn.

The discharge chute is blocked.

Stop the product. Make sure that all moving parts have 
come to a complete stop. Allow the product to cool down. 
Disconnect the spark plug wire. Remove grass catcher 
and lift discharge chute cover. Beware of the sharp blade 
and avoid contact. Remove the debris from the discharge 
chute.