Bosch MMBH6P6B - Инструкция по эксплуатации - Страница 21

 21

 en

Safety systems

Safety systems

Start lock-out and 

automatic cut-out

The appliance can only be operated if the 

blender jug has been correctly positioned 

and if the rotary selector is turned to 

the zero setting when switching on the 

appliance or after an interruption in the 

power supply. The appliance will switch off 

automatically if the blender jug becomes 

detached while it is running. The appliance 

automatically switches off in manual mode 

(speed 

min

 – 

max

) after 5½ minutes of 

continuous operation. 

X

 “Troubleshooting” 

see page 21

Overload protection

The motor switches off automatically if the 

appliance overheats. 

X

 “Troubleshooting” 

see page 21

Note:

 When activating the overload 

protection, a slightly strange smell may 

occur. This is not a sign of malfunction.

Troubleshooting

W

Risk of injury!

Before dealing with any faults, unplug the 

mains plug.

Note: 

The appliance will no longer 

switch on if there is an error in appliance 

operation, if the electronic fuses trip or the 

appliance has a defect. First try to eliminate 

the problem which has occurred with 

the help of the following information.

Caution!

If a fault cannot be eliminated, please 

contact customer service.

Fault

Appliance fails to start up or switches off 

while in use. The status display flashes.

Possible causes

– Blender jug is not correctly positioned, 

has become detached or has been 

removed.

–

Rotary selector was not at the zero 

setting when switching on or after an 

interruption in power.

–

The appliance was operating 

continuously in manual mode (speed 

min

 – 

max

) for longer than 5½ minutes.

Remedy

■ Switch off the appliance with the on/off 

switch.

■

Position the blender jug correctly.

■ Turn the rotary selector in an 

anticlockwise direction as far as it will go 

(zero setting). 

■ Switch on the appliance with the on/off 

switch. The status display lights up.

Fault

Appliance fails to start up or switches off 

while in use. 

Possible cause

The overload protection device is activated.

Remedy

■ Turn the rotary selector in an 

anticlockwise direction as far as it will go 

(zero setting).

■ Switch off the appliance with the on/off 

switch. Disconnect the mains plug.

■

Remove the blender jug.

■

Leave the appliance to cool for approx. 

15-20 minutes and then switch it on 

again.

■

If the appliance does not start, turn the 

appliance upside down. Press the reset 

button on the bottom (

X

Fig.

A

 - 

1c

).

■

If the reset button is blocked, leave the 

appliance to cool again and try it again 

later.