Timberk SWH FED1 30 V - Инструкция по эксплуатации - Страница 6

www.timberk.com • electrical storage water heater

6

1. Power cord 
2. Water outlet
3. Hot water supply adjustment cock*
4. Mixer*
5. Shower header*
6. Cold water supply adjustment cock*
7. Discharge pipe
8. Composite pressure-relief valve
9. Water inlet
10. Magnesium anode – water discharge nozzle
11. Water main shut-off valve
12. Water main

* not included in the delivery set

Water heater mounting methods

Fig.3 shows the way to mount the water heater for one consumption point.

Fig. 3

Vertical position

6.  DELIVERY SET

1. Water heater – 1 pc.
2. Anchor bolt – 2 pcs.
3. Pressure safety valve – 1 pc.
4. Discharge pipe – 1 pc.
5. Operation manual and guarantee card – 1 pc.
6. Packing – 1 pc.

7. WATER HEATER INSTALLATION

Location

1. Electric water heater should be mounted on a firm wall. If the wall is not 

robust enough to hold the weight equal to the doubled weight of the total 

water heater weight, fully filled with water, then it should be mounted on a 

special support.
2. The wall, where the electric water heater is to be mounted, must withstand 

at least the double weight of the water heater, fully filled with water; there 

must be no cracks and other damages on the wall. Otherwise it is necessary 

to take measures to strengthen the mounting or mount the water heater on 

a special support.
3. If a bathroom is too small, the water heater can be installed elsewhere, 

unexposed to direct sunlight and unavailable for moisture. However, to 

reduce heat losses in pipelines, the location, where a water heater is to be 

installed, must be as close to the place, where hot water is used, as possible.

IMPORTANT! 

The water heater must be mounted on a vertical wall 

only the position, specified in Fig.3. Mounting of the 

appliance in any other position or vertical or horizontal 

tilting will inevitably result in failure of the water heater, 

emergency situation and is considered a non-guarantee 

case by the manufacturer.