Philips GC9140/02 - Инструкция по эксплуатации - Страница 9

storage

  1 

 Switch off the appliance (1) and unplug it (2) (Fig. 21).

 - Press the cord rewind button to store the cord.

 - Empty the Calc Clean tank if it is filled.

  2 

 Wind the supply hose round the bottom of the steam generator (Fig. 22).

Note: Make sure the supply hose sits properly in the storage groove and inside the bracket.

  3 

 Place the heat-resistant iron resting mat on the steam generator and put the iron on the 

mat (Fig. 23).

Note: You do not have to wait for the appliance to cool down. You can store the appliance immediately 

after use.

  4 

 Slide the carry lock slide to the right to lock the iron onto the steam generator (Fig. 24).

  5 

 With one hand, you can now easily carry the whole appliance by the handle of the 

iron (Fig. 25).

troubleshooting 

This chapter summarises the most common problems you could encounter with the appliance. If 

you are unable to solve the problem with the information below, please contact the Philips 

Consumer Care Centre in your countr y. 

Problem

Possible cause and solution

The appliance does 

not become hot.

There is a connection problem. Check the mains cord, the plug and the 

wall socket.
The appliance has not been switched on. Set the on/off knob to ‘on’.
The set temperature is too low. Set a higher temperature.

Smoke comes out of 

my new ironing 

system when I switch 

it on.

Some par ts of the appliance have been lightly greased in the factor y and 

may initially give off some smoke when heated. This phenomenon is 

perfectly normal and ceases after a shor t while

The appliance does 

not produce any 

steam.

There is not enough water in the water tank. Fill the water tank.

The steam generator has not heated up sufficiently. Wait approx. 2 

minutes.
The set ironing temperature is too low for steam ironing. Select a 

temperature of 

2

 or higher.

The water tank is not placed properly in the steam generator. Place the 

water tank properly in the steam generator (‘click’).
When the temperature dial is set to a ver y high temperature, the steam 

produced is dr y and hardly visible. It is even less visible when the 

ambient temperature is relatively high and it is entirely invisible when the 

temperature is set to MAX. Set the temperature dial to a lower 

temperature, e.g. 

2

, to check if the iron produces steam.

EnGlish

9